B&W Turnoverball Hole Location on 2003 Chevrolet Silverado 2500HD
Updated 10/22/2025 | Published 04/07/2025
Question:
where do i cut the hole for gooseneck 2003 2500 hd
asked by: Mcledbetter
0
Expert Reply:
The answer to your question depends on the bed length. Do you have an 8' bed or a 6-1/2' bed? Measure from the back end of the truck bed floor by hooking a tape measure over the back of the truck box and mark the floor at the correct measurement. Next, center the location between the wheel wells. This will be the center point for the four inch hole for the # BWGNRK1067. If you have an 8' bed measure 49-1/2" and for a short bed 44-1/4".
expert reply by:
Robin H
0
Turnoverball Installation
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
B&W Turnoverball Underbed Gooseneck Trailer Hitch w/ Custom Installation Kit - 30,000 lbs
- Gooseneck Hitch
- Below the Bed
- Flip-Over Ball
- 7500 lbs TW
- 30000 lbs GTW
- Wheel Well Release
- Spring-Loaded Loop
- B and W
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Recommended Air Bags and How to Adjust the PSI on a 2009 Dodge Ram 3500
- Q&A: Recommended Reese Goosebox to Replace a Curt Rota-Flex Pin Box
- Article: Adapters for Towing a 5th Wheel Trailer with a Gooseneck Hitch
- Q&A: What Lock Kit Is Needed For My B&W Pintle Hitch?
- Q&A: Where Does The Red Wire Install to On the Roadmaster Brake-Lite Relay Kit 2007 Hummer H3
- Q&A: What is Difference Between B and W Turnoverball Gooseneck Hitches that Fit 2007 Chevy Silverado
- Q&A: Transferring B&W Gooseneck Hitch to 2006 Chevy Silverado 2500
- Q&A: Can 5th Wheel Trailer be Towed with BAKFlip Tonneau Cover Folded Flat on 2018 Ford F-350
- Article: Gooseneck to 5th Wheel Adapters
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Holiday 2025 | Best Gifts for Towers
- Article: 5th Wheel to Gooseneck Adapters
- Article: Ram Trailer Tow Prep Package
Robin H.
10/22/2025
Hey, how did your measurements go for cutting the hole in your truck bed for the B&W Turnoverball hitch? Were the distances from the back of the bed accurate for your setup? Sharing what worked could help others doing the same install.