bing tracking image
Q & A Icon

Availability of 15 inch Extension Built into Lock N Roll Articulating Coupler  

Updated 04/06/2025 | Published 03/22/2025

Question:

I have a lock n roll hitch and purchased a GenY 14 inch extension to get the trailer back from my rear van doors. When I tried to hook up I found that the hitch shaft flairs out at the hitch end, enough that the holes on the hitch and extension will not line up. Had to send it back. Had to pay shipping so that lesson cost me $20. I would like to know if the lock n roll hitch will work with this extender and since you sell both it would be great if you would actually put the two together and see if the holes line up. Would you be able to do that for me/us?

0

Expert Reply:

Hey Timothy, since you need about 15 inches of extension and you have a Lock N Roll setup your best option would be just to go with the part # 336TS520 which has 15 inches of extension built into it. Would that work for you?

expert reply by:
0
Jameson C
Timothy J. profile picture

Timothy J.

3/28/2025

That trailer side part is made for a trailer that has a receiver type end. You slide that into it and pin it. My trailer has the part bolted onto the tongue. Can you do what I originally asked you to do? I understand if you are not allowed to do that with new parts but you guys do demos on video everyday.

Jameson C. profile picture
Etrailer Expert

Jameson C.

3/31/2025

@TimothyJ Sorry about that. There's no reason the etrailer hitch extender part # e28YR wouldn't work with your Lock N Roll vehicle side setup. This provides the exact same size hitch opening that your vehicle has so unless there's something out of spec or damaged there's no reason it would wouldn't work. I don't know which Lock N Roll hitch you have though. The 2 inch hitch opening of the # e28YR does not have any taper to it and is very deep so there would be no issue with it tapering down to narrow to fit any hitch accessory.
Timothy J. profile picture

Timothy J.

4/3/2025

@JamesonC it is a subtle flare enough that it will not line up with a GenY 14 inch extension. Why would I spend $20 and all this effort if it did. I have a picture that shows the end. I wish I had taken a picture of it with the GenY extension. Can't seem to post the picture here. Send me an email and I'll send it to you.
Jameson C. profile picture
Etrailer Expert

Jameson C.

4/3/2025

@TimothyJ my email is [email protected]
See All (6) Replies to Timothy J. ∨

Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>