Is it Just a Nut and Cotter Pin That Holds an Ilder Hub to the Spindle on a Trailer
Updated 11/03/2025 | Published 01/17/2025
Products Featured in This Question
Question:
Is the only thing holding the hub/wheel onto the spindle assembly a nut and cotter key? AKIHUB-545-35-EZ-K hub ASR2KHDS04 suspension
asked by: Brad W
Expert Reply:
Hey Brad, thanks or reaching out!
Yes, ultimately, it's just the castle nut and cotter pin that comes with the Timbren Kit # ASR2KHDS04 that will be keeping the idler hub # AKIHUB-545-35-EZ-K on the spindle.
It sounds a little wild when you think about it, but those keep the hub pretty snug on the spindle, and there are other things like the bearings and grease seal that help make it a seamless connection for a smooth ride as well. This is also the industry standard for trailer hubs so if it freaks you out a little just know that if it really were dangerous then we would be seeing trailer hubs and wheels flying off all other the highway.
Did you have any other questions about this setup?
Product Page this Question was Asked From
Easy Grease Trailer Idler Hub Assembly for 3.5K Axles - 5 on 4-1/2 - Pre-Greased
- Trailer Hubs and Drums
- Idler Hub
- EZ Lube
- Pre-Greased
- L68149 / L44649
- Standard Grade
- For 3500 lbs Axles
- 1/2 Inch Stud
- 5 on 4-1/2 Inch
- 13 Inch Wheel
- 14 Inch Wheel
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: What is a #84 Spindle and How Do I Know I Have One On My Trailer?
- Q&A: Correct Hub for Dexter EZ Lube 3,500-lb Axle
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: Replacement Hub for Tie Down Engineering 11033
- Q&A: Replacement Idler Hub for a Dexter 3,500 lbs Axle
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: Is Drilling Required For Installation Of Roadmaster Front Anti-Sway Bar on 2026 Jayco Melbourne 24L
- Q&A: Proper Way to Tighten Trailer Spindle of Castle Nut
- Q&A: Replacement Hub Assembly for T.D.E. 11033
- Article: Most Popular Wheel Bearings
- Article: Trailer Wiring Diagrams
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: 7 Common Questions Everyone Has About Trailer Tires
Jon G.
11/3/2025
Hey Brad, how did things turn out with the hub and spindle setup on your Timbren suspension? Did the fit with the nut and cotter pin feel secure once everything was in place? Your update could make it easier for others working on the same combo.