Wall Thickness of Demco Gooseneck Coupler Outer Tube part # DM63KV

Question

Question:

Wall thickness?

asked by: James M

0

Expert Reply:

Hey James, the wall thickness of the Demco Gooseneck Coupler Outer Tube part # DM63KV is 1/4 of an inch.

expert reply by: Jameson C

0

Jameson C.

11/3/2025

Hey James, did the 1/4-inch wall thickness on the Demco gooseneck coupler tube meet what you needed for your setup? Knowing how it worked out could help others checking strength and fit for their trailers.

Answer 1

Hey Tony. The Dexter Dual Hydraulic Jack System w/ Double Acting Pump item #DX42CR does not have a self leveling function. It's either up or down. The pivoting foot pads on the bottom of the jacks are what this system relies on when you're…

view full answer...

Answer 2

For a Bulldog 180 series jack you will need replacement drop leg pin #BD500177. It includes the spring, cotter pin, and washer. You should not have to remove the inner drop leg to replace the pin and spring. Start by pulling back on the pin. Then use…

view full answer...

Answer 3

As long as your dual wheel has a flat surface where the Flange Wheel Nut #95188 would rest against, like what the Dexstar Dual Wheel #AM20790 has, then you would use this flange wheel nut in the place of a nut with a 90 degree cone. Attached is a…

view full answer...

Answer 4

Hi Alan, welcome back! You can use the Mounting Bolts and Hardware #BRKH12S to mount the Replacement Mounting Bracket for DeeMaxx Disc Brake Caliper #DE55VR to the brake flange.

view full answer...

Answer 5

Hello Jerry, Great question. It all depends on on if it is compatible. If your current set up is not a topwind coupler then it isn't going to work because the #GCSQTW-30008 does not use traditional pin-adjustment holes (please refer to picture I…

view full answer...

Answer 6

The flicker you are seeing on the brake output circuit of your vehicle is normal. Brake controllers will lightly pulse their output circuit to check to see if a trailer is connected due to the amperage draw of the brake magnets. So what this all…

view full answer...

Answer 7

I recommend at least 6" of clearance from the top of your bed rails on your 2021 Ram 3500 to the underbelly of your gooseneck or 5th wheel trailer. If using a gooseneck trailer and if you have the factory in bed prep/puck system there are…

view full answer...

Answer 8

While we do have a video of a trailer wiring harness installation on a 2012 Kia Sorento, it is not for the Curt T-Connector Vehicle Wiring Harness #C56328. Instead, the video we have, which I have linked for you below, is of an installation of the…

view full answer...

Answer 9

You can refer to the linked diagram for general guidelines about minimum clearances required when towing. If you have 8 or 9-inches of vertical clearance between the bed rails and the trailer you should be fine since 6-inches is considered adequate…

view full answer...

Wall Thickness of Demco Gooseneck Coupler Outer Tube part # DM63KV

Product Page this Question was Asked From

Continue Researching