What is Offset with Andersen Ultimate Connection 5th Wheel Trailer Hitch System # AM3200

Question

Question:

I have toyota tundra 6.5 ft bed. Will this hitch allow for a set back of how much. Currently I have a sliding hitch. Thanks

asked by: Stuart C

0

Expert Reply:

The Andersen Ultimate Connection 5th Wheel Trailer Hitch System # AM3200 provides an offset, or set-back, of 9-inches to allow use in truck beds as short as 6-feet. Your 6-1/2-foot bed Toyota Tundra is compatible with this system, which has a tongue weight limit of 4000-lbs and a gross towing capacity of 20K.

expert reply by: Adam R

0

Answer 1

I attached a picture that shows the installation instructions for the Conver a Ball Adapter part #CAB-C5GX1216 that you referenced as well as an install video for you to check out.

view full answer...

Answer 2

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 3

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 4

Hey Doug! The Firestone Ride-Rite Air Helper Springs #F35FV are the right kit for your 2026 Ford F-350 FX4 dually. However, you will need to measure to be sure it fits. The distance from the top of your rear axle to the top of the jounce bump stop…

view full answer...

Answer 5

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 6

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

Answer 7

Hey Jeff. There is definitely a correlation between weight and capacity. I've listed the weight of all three of the Power Mountain Tallboy Off-Road Bottle Jacks we have below: Power Mountain Tallboy Off-Road Bottle Jack - 7-15/16" to…

view full answer...

Answer 8

Hey Neil. The 18,000 Btu Furrion Chill Cube RV Air Conditioner item #LC34DX fits a 14-1/4" x 14-1/4" cutout which is pretty standard on RV's. If you meant to write Dometic instead of domestic then yes it'll fit in your existing…

view full answer...

Answer 9

We have lift kits for trailer that easily add 2 inches to the height of the trailer. For that you'd want the part #RR23QX and you'd be set. I attached a picture that shows how it installs to give you an idea. This would be the easiest…

view full answer...

Answer 10

Hey Matt, so the biggest difference between the Hellwig and Roadmaster sway bars that fit your 2022 Ford F-350 is the diameter of them which is what directly influences how stiff they are. The Hellwigs are a smaller diameter than the Roadmaster so…

view full answer...

Answer 11

With a 2022 F350 short bed, hitting the top of the bed rails should not be an issue with most campers. Turning clearance however, will certainly be a factor. That is one advantage of the Andersen Ultimate hitch #AM3200, as it provides a 9"…

view full answer...

Answer 12

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

What is Offset with Andersen Ultimate Connection 5th Wheel Trailer Hitch System # AM3200

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching