Installing/Replacing # DL21562 Rocker Roller On A Boat Trailer
Updated 05/28/2014 | Published 05/25/2014
Products Featured in This Question
Question:
Are these hard to install on your own?
asked by: Paul R
0
Expert Reply:
Not at all, the procedure is really very simple. You'd use pliers to remove the existing Hog or Retainer Ring, remove the old washer (if present) and remove the existing roller. Install the new roller, replace the # CE10983 washer and install a new # CE10981 retaining ring by slipping it over the shaft and crimping it with pliers. This roller is designed to work on a 3/4 inch diameter shaft.
expert reply by:
Mike L
0
Product Page this Question was Asked From
Boat Trailer 4-1/4" Diameter x 4-1/4" Long Rocker Roller by Dutton-Lainson
- Accessories and Parts
- Boat Trailer Parts
- Roller Parts
- 4-1/4 Inch Diameter
- Rollers
- 4-1/4 Inch Wide
- Dutton-Lainson
more information >
Continue Researching
- Q&A: What Surge Coupler is on Military M1102 MCC Trailer
- Q&A: Grease Maintenance Schedule for Lippert Ground Control LCI 3.0 Leveling Jacks
- Q&A: Are Dexter Model 6 and Demco DA91 Inner Slides the Same Dimensions
- Q&A: Where Do the Rubber Bearings Go On the Titan/Dico Model 10 Surge Brake Actuator
- Q&A: Replacement Front Roller for a Model 6 Brake Actuator
- Q&A: Does Replacement Hand Wheel Lock for Model 6 and 60 Actuator Come with Spring
- Q&A: Replacement Front Roller for a Surg-o-Matic Model 6 Actuator