Replacement Cover for Fan-Tastic RV Roof Vent

Question

Question:

I need a replacement cover for fan-tastic vent model 810060 mfg 8/14. Do you have?

asked by: Corky

0

Expert Reply:

Hey Corky, the correct replacement cover for your Fan-Tastic RV roof vent # FVK1020-19.

expert reply by: Jameson C

0

Jameson C.

1/19/2026

Hey Corky, how did the replacement cover for your Fan-Tastic vent work out? Knowing how it fit could help others looking for the same part.

Answer 1

Hello Richard, thanks for reaching out. The Replacement Dome for Dometic FanTastic RV Roof Vents #FVK1020-19 does looks very similar to the vent lid in your picture, but we'll need to look more closely at how your current lid attaches. The…

view full answer...

Answer 2

Hey Aaron, since it's a Fan-Tastic roof vent the correct lid would be the part #FVK1020-19 that you referenced. They've only used the one roof vent lid design over the years.

view full answer...

Answer 3

Since we don't have a confirmed fitting replacement for a 7300 I recommend taking a few measurements of your current cover's mounting hole locations and seeing it will match up to the Replacement Dome for Fan-Tastic Vent RV Roof Vents -…

view full answer...

Answer 4

Hey Jeremy, thanks for reaching out! The slider track that comes on the Replacement Dome for Dometic FanTastic RV Roof Vents #FVK1020-19 only comes with the lid and unfortunately isn't available on it's own. You might be able to find it from…

view full answer...

Answer 5

Thank you for the photos! From what I'm seeing it looks like you need the Replacement Lift Arm #FVK8011-05 and the Replacement Dome #FVK1020-19 for your main vent. The dome should be an exact replacement while the lift arm doesn't have the…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

You can use the RV Propane Gas Detector #RS64FR (white) or #RS44FR (black) to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 8

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 9

Hello Sam; that is a great question! I reached out to Furrion and you will be able to use the Furrion Chill Cube #FR69TD (white) or #FR49TD (black) with your furnace. However, the remote is not capable of operating the furnace at this time. Also, we…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 12

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

Replacement Cover for Fan-Tastic RV Roof Vent

Product Page this Question was Asked From

Continue Researching