Replacement Roof Vent Lid for Fan-Tastic RV Roof Vent

Question

Question:

Looking for a replacement vent cover for an older model fan-tastic vent that is on my 2016 Lance 2185 Fan-tastic VEN model FV2200XWUSD81. Please advise

asked by: Aaron B

0

Expert Reply:

Hey Aaron, since it's a Fan-Tastic roof vent the correct lid would be the part # FVK1020-19 that you referenced. They've only used the one roof vent lid design over the years.

expert reply by: Jameson C

0

Aaron B.

11/13/2025

Super helpful, thank you very much.

Jameson C.

11/13/2025

@AaronB Glad I could help!

Answer 1

Hello Richard, thanks for reaching out. The Replacement Dome for Dometic FanTastic RV Roof Vents #FVK1020-19 does looks very similar to the vent lid in your picture, but we'll need to look more closely at how your current lid attaches. The…

view full answer...

Answer 2

Hey Jeremy, thanks for reaching out! The slider track that comes on the Replacement Dome for Dometic FanTastic RV Roof Vents #FVK1020-19 only comes with the lid and unfortunately isn't available on it's own. You might be able to find it from…

view full answer...

Answer 3

Hey Corky, the correct replacement cover for your Fan-Tastic RV roof vent #FVK1020-19.

view full answer...

Answer 4

Since we don't have a confirmed fitting replacement for a 7300 I recommend taking a few measurements of your current cover's mounting hole locations and seeing it will match up to the Replacement Dome for Fan-Tastic Vent RV Roof Vents -…

view full answer...

Answer 5

Thank you for the photos! From what I'm seeing it looks like you need the Replacement Lift Arm #FVK8011-05 and the Replacement Dome #FVK1020-19 for your main vent. The dome should be an exact replacement while the lift arm doesn't have the…

view full answer...

Answer 6

Hey Stan, since you said you have a Fan-Tastic roof vent and the lid you need to replace is flat the correct replacement part would be the part #DMC66FR.

view full answer...

Answer 7

I am afraid we are not able to tell specifically what model of FanTastic vent you have based on your pictures. It certainly appears to be an older model. If you are looking to replace individual parts of your fan we will need to know the exact model.…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 10

You can use the RV Propane Gas Detector #RS64FR (white) or #RS44FR (black) to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Replacement Roof Vent Lid for Fan-Tastic RV Roof Vent

Product Page this Question was Asked From

Continue Researching