Looking For 7,000 lb Hub With 8 on 6-1/2" Bolt Pattern and 5/8" Studs
Updated 02/03/2026 | Published 07/10/2024
Products Featured in This Question
Question:
Im looking for a 7000 lb trailer wheel hub. 8 on 6.5 with 5/8 inch studs. Just need hub and bearings. Thanks
asked by: David
0
Expert Reply:
Hello David. The Dexter Trailer Hub and Drum Assembly # 8-219-18UC3 does fit all of your parameters. This is a 7K hub with the 8 on 6-1/2" bolt pattern and 9/16" studs. This hub uses the standard 7K bearing combination, with the # 25580 (1.750" inner diameter) inner bearing and the # 14125A (1.250" inner diameter) outer bearing. Bearings, races, seal, grease cap and lug nuts are included.
expert reply by:
Jesse M
0
Product Page this Question was Asked From
Trailer Hub and Drum Assembly - 7,000-lb Axles - 12" Diameter - 8 on 6-1/2 - Pre-Greased
- Trailer Hubs and Drums
- Hub with Drum
- Pre-Greased
- Standard
- 25580 / 14125A
- Standard Grade
- For 7000 lbs Axles
- 1/2 Inch Stud
- 8 on 6-1/2 Inch
- 16 Inch Wheel
- 16-1/2 Inch Wheel
- 17 Inch Wheel
- 17-1/2 Inch Wheel
- etrailer
more information >
Continue Researching
- Q&A: Looking For Replacement Bearing For Square Tube Top Wind Trailer Jack
- Q&A: Upgrade Kit for 2-1/4 inch Trailer Suspension Shackles
- Q&A: Replacement Electric Brakes For A 2023 Brinkley Z 3100 5th Wheel With 7k Axles
- Q&A: Replacement For 125255UC Grease Seal
- Article: Trailer Wiring Diagrams
- Q&A: Can 1/2 Inch Wheel Studs be Changed to 9/16 Inch Wheel Studs
- Q&A: Troubleshooting Stillwell 7k Hydraulic Jack that Raise/Lower
- Q&A: Can Thicker U-Bolts Be Used for Trailer Axle
- Article: Most Popular Wheel Bearings
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Trailer Lighting Requirements
- Article: How to Choose the Right Trailer Hitch Class
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
Jesse M.
2/3/2026
Hey David, did the Dexter hub and drum assembly end up being the right fit for your 7,000‑lb trailer setup? Knowing how it worked out could help others looking for the same hub and bearing combo.