Steps Will Not Retract On A 2022 Mirada 37' RV And Motor Makes Clicking Noice

Question

Question:

2022 Mirada 37 feet. The steps will not come in. Undo a wire under rv and when hooking back up the motor makes clicking noise like it wants to work

asked by: Bill

0

Expert Reply:

Hello Bill, thanks for reaching out. The issue you are describing sounds like a problem with the motor. Generally when you get that clicking noise from the motor like it is trying to work but wont work it means you motor is going bad and will need to be replaced.

There should be a sticker on your motor with a part number or model number. Go ahead and post that number in the comments below and I am happy to recommend a replacement.

expert reply by: Jesse M

0

Answer 1

The 334850 part number you mentioned refers to the Replacement Control Switch #LC334850. This particular unit replaces the control switch assembly for certain Lippert Tread Lite RV Steps ( #LC353542, #LC353543, #LC353620, or #LC353621).

view full answer...

Answer 2

To replace the cables that came with your side cameras #RVS-775L and #RVS-775R we have the following parts: - Safety Adapter Cord #RVS-RCA5-AM - Female Power Cable #RVS-RCA-P - 33' Extension Cable #RVS-104N If you're talking about the cable…

view full answer...

Answer 3

The Replacement Step Control Module #LC334850 is specifically designed for the Tread Lite steps. I'm not sure that necessarily makes it special but it does mean it is the only solution to replace your current 334850. I wish I could tell you the…

view full answer...

Answer 4

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 5

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 6

Hey Melanie. The reason you can't find a replacement for your GE ARC15AACBL2 15,000 btu air conditioner is because they phased them out. In 2025 all RV AC systems had to change over to a new coolant called R32. This was a EPA mandated decision.…

view full answer...

Answer 7

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 8

Hey Donny! For your Dometic Penguin/Brisk Air 15,000 BTU AC model B59516.711C0-MX, the correct soft start is the #DMC93JF. This is designed for Dometic Brisk II electronic air conditioner units with in-wall thermostats.

view full answer...

Answer 9

That’s a great question Chadwick, and this is one of those situations where the change in technology really matters. The GE Appliances Low-Profile RV AC w/ Heat Pump part #GE26RR will replace your current ARC13AACBL2 setup, but it’s important to know…

view full answer...

Steps Will Not Retract On A 2022 Mirada 37' RV And Motor Makes Clicking Noice

Product Page this Question was Asked From

Continue Researching