Wiring Diagram For Lippert Electric Tread Lite Step # LC353620 To Bench Test Steps

Updated 02/28/2022 | Published 02/25/2022

Products Featured in This Question

Replacement Motor for Lippert Tread Lite Powered RV Steps - Qty 1

(8)

$635.84

Lippert Electric Tread Lite Step for RVs - Single - 5" Drop/Rise - 30" Wide - Aluminum

(56)

$808.93

Question:

Ive replaced the transmission on my Lippert step, but now I want to test it before I put it on the RV. I can find no wiring diagram or testing method for these steps. there are two wires that go to the motor and two that go to the clutch on the back of the motor. How do I test the steps?

asked by: Roderick E

Expert Reply:

To bench test the Motor # LC183058 on your Lippert Electric Tread Lite Step # LC353620 you can simply connect the motor wires a 12 volt battery source to operate the motor. The motor is reverse polarity so you can run it in and out by alternating the 12 volt wiring on the motor.

I have included an image of the wiring diagram for these steps if you wish to further test the different switches through the step controller.

expert reply by: Bud M