Recommended Air Bag Kit for 2020 Ram 1500 With 3" Lift

Question

Question:

I have a 3in Fox lift kit on my 2020 Ram 1500. Looking for load Lifter 5000, but to accommodate the 3in lift. The Fox rear lift is done with just springs and shocks, no spacers and no changes to suspension.

asked by: Al V

0

Expert Reply:

Hey Al, the Air Lift LoadLifter 5000 Ultimate Air Helper Springs with Internal Jounce Bumpers # AL88375 you're looking at will still work fine with your lifted Ram 1500, you're just going to need to add the spacer # AL52420 and you'll be all set.

This is only a 2" spacer, but the mounting brackets in the kit will take up around an inch so, so when they're paired together they'll work great to cover your 3" lift.

expert reply by: Bryce D

0

Alfred J.

5/21/2024

thanks for the help

Bryce D.

5/21/2024

@AlfredJ Anytime, Al.

Answer 1

Hello David, thanks for reaching out. It is possible to put air bags on your 2004 Ram 1500, and there are spacers available which make the kits fit lifted trucks. I suggest going with an Air Lift brand kit, part #AL57230 for 4WD trucks or part…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 5

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 6

To install a Redarc Tow Pro Liberty in your 2023 Toyota Tacoma Sport you will need the following parts: Redarc Tow-Pro Liberty Brake Controller item #RED24FR Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item #RED99FR…

view full answer...

Answer 7

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 8

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

view full answer...

Answer 9

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 10

Hey Hadiya! No, the Curt E16 5th Wheel Hitch w/ S20 Slider for Ram #C85PV will not give you enough clearance to maneuver the Layton Skyline 5th wheel with your 2021 Ram 1500 with a 5-1/2' bed. This unit only moves you 12" back from the…

view full answer...

Answer 11

Hey John, thanks for the picture of your truck bed! To install a set of 5th wheel rails in your 2022 Ram 2500, I recommend the B&W Custom Installation Kit w/ Base Rails item #BWRVK2602. This set of rails are industry standard so they'll work…

view full answer...

Answer 12

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...