Replacement Tail Light For 5X10LGW2K Trailer

Question

Question:

Hello, I have a 5X10LGW2K trailer and looking for the right rear tail light and the back ramp. Can you provide the part numbers?

asked by: Daniel L

0

Expert Reply:

Hi Daniel,

I was able to Google the correct tail lights for your trailer and while we don't have a ramp, here is what you need for tail lights. I know you said right tail light, but 'll go ahead and list out both the driver and passenger side options in case you need both at some point.

- Passenger Side: LED Trailer Combination Tail Light # STL38RB

- Driver Side: LED Trailer Combination Tail Light # STL39RB

expert reply by: Kyle S

0

Answer 1

Hello Dave, Yes, the Combination LED Trailer Tail Light - Submersible - 6 Function - 11 Diodes - Passenger Side #STL8RGB is the better half to the Combination LED Trailer Tail Light - Submersible - 7 Function - 14 Diodes - Driver Side #STL9RGB. The…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 4

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 5

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 6

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 7

Hey Tim welcome back! Your ARH15AACBL2 GE AC unit has the old 410a refrigerant in it so the GE Appliances item #GE64FR you were looking at isn't going to work as a replacement. The EPA mandated R32 refrigerant has been used in all new AC's…

view full answer...

Answer 8

Hey Rick. Unfortunately that's correct the Wesbar Tail Light 271594 has been discontinued. Our best option for replacing it is the LED Trailer Tail Light item #STL36RB for the passenger side and item #STL37RB for the driver side. The Wesbar light…

view full answer...

Replacement Tail Light For 5X10LGW2K Trailer

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching