Replacement Bushings for a Roadmaster TruTrac Rod Kit on a 2005 Workhorse W22

Question

Question:

Are these the correct part numbers for bushings4 ea. and sleeves2ea. for a Roadmaster Davis Front Trac Bar W-22? fitment: 2005 Workhorse W22

asked by: Rick

0

Expert Reply:

No, they are not. For the Roadmaster TruTrac Rod Kit item # RM-1259-106 we only have the Replacement Polyurethane Bushing item # RM-205209-00 which is part number 23 on the installation instructions linked below. They're sold individually.

The sleeve you are looking for is part number 205504-00, number 22 on the installation instructions, and we do not have it.

The Item # RM-1259-106 is a kit that includes the Davis TruTrac and a front anti-sway bar.

expert reply by: Jerred H

0

Answer 1

The Roadmaster Replacement Bracket U Clamp for RM Front Sway Bar 1139-140 #RM-B141 measures 4 inches center of bolt hole to center of bolt hole, 5-1/2 inched end to end, 3 inches top to bottom, 1.975 inches inside, and the bolt hole measures 0.74…

view full answer...

Answer 2

If your 2004 Ford F-53 V8 or V10 motorhome is less than 34-feet long and is equipped with Roadmaster Sway Bar #RM-1139-143 then the correct replacement polyurethane bushing is part #RM-205209-00. Please note this is sold as a single bushing, not a…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 7

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 8

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 9

Hello Sam; that is a great question! I reached out to Furrion and you will be able to use the Furrion Chill Cube #FR69TD (white) or #FR49TD (black) with your furnace. However, the remote is not capable of operating the furnace at this time. Also, we…

view full answer...

Answer 10

Hey Doug! The Firestone Ride-Rite Air Helper Springs #F35FV are the right kit for your 2026 Ford F-350 FX4 dually. However, you will need to measure to be sure it fits. The distance from the top of your rear axle to the top of the jounce bump stop…

view full answer...

Answer 11

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Answer 12

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Replacement Bushings for a Roadmaster TruTrac Rod Kit on a 2005 Workhorse W22

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching