Dimensions on Roadmaster Replacement Bracket U Clamp

Published 10/27/2015

Products Featured in This Question

Replacement U-Clamp Bracket for Roadmaster Anti-Sway Bars

(11)

$32.63

Roadmaster Front Anti-Sway Bar and Bushing Kit - 1-5/8" Diameter

(2505)

$710.00

Roadmaster Bracket for Anti-Sway Bar Split Bushings

(18)

$28.49

Question:

I have a workhorse chassis in our shopI need the dimensions of this bracket to insure I get the correct bracket?? This is the bracket on the lower control arm.

asked by: Dave

Expert Reply:

The Roadmaster Replacement Bracket U Clamp for RM Front Sway Bar 1139-140 # RM-B141 measures 4 inches center of bolt hole to center of bolt hole, 5-1/2 inched end to end, 3 inches top to bottom, 1.975 inches inside, and the bolt hole measures 0.74 inches. I have attached a diagram showing these measurements.

This bracket is designed as a replacement part for the Roadmaster Front Sway Bar 1209-100. Based on my research, the Roadmaster Anti-Sway Bar for the 2002 Workhorse P Series is part # RM-1109-116. For the # RM-1109-116 system, you would want to use the # RMB140 bracket.

expert reply by: Victoria B