Can The Optronics LED Light Strip # UCL90CB Be Cut In Half?

Question

Question:

can i , cut this in half and run on both sides of my trailer frame. If so how do I connect the other side with no wire leads to the power source

asked by: Scott H

0

Expert Reply:

Yes, you can cut the Optronics Flexible LED Light Strip # UCL90CB in half and run both sides down your trailer frame. There is actually a short wiring lead on both ends of the strip so you will have what you need to wire both sections. Do be sure to use some sealant like Liquid Electrical Tape # SWC50122 to seal up the ends where you cut it in half.

expert reply by: Bud M

0

Answer 1

We've spoken with Command Electronics in the past and they have told us that the #328-K-0054BS has Lumen output of 4,000.

view full answer...

Answer 2

For an LED light strip you can use the 17 foot Optronics Flexible LED Light Strip #UCL90CB. Since you mentioned you needed two of these - which can be cut to length - you will also need the connector, which is the Optronics LED Light Strip Connector…

view full answer...

Answer 3

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 4

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 5

Hey Marc, When it comes to anti-sway bars the thicker the better they'll perform so you'll want measure the thickness of your current bars and swap them out accordingly. The thickest options we offer for your 2024 GMC Sierra 3500 are the…

view full answer...

Answer 6

Hey Patti, thanks for reaching out. The Swagman E-Spec Pro Bike Rack #S45SR is a solid option for this. It can hold two bikes weighing up to 70 lbs apiece on a 5th wheel, and it does not have a minimum tongue weight capacity limitation like the…

view full answer...

Answer 7

Hey Melanie. The reason you can't find a replacement for your GE ARC15AACBL2 15,000 btu air conditioner is because they phased them out. In 2025 all RV AC systems had to change over to a new coolant called R32. This was a EPA mandated decision.…

view full answer...

Answer 8

Hello Jerry, Thank you so much for the pictures, they are always most helpful! I am sorry but there is not a seal packing kit, you will need to replace the entire jack. For your Lippert Level Up with part number 343315-RA, you will want the…

view full answer...

Answer 9

Hi Glen, It will depend on what the GVWR (gross vehicle weight rating) is of your trailer to determine which B&W 5th wheel to gooseneck adapter will work best for you. Fifth wheels and gooseneck trailers go off of pin weight instead of tongue…

view full answer...

Answer 10

Hello Jay, I’m curious what panel you’re planning to use. How many panels will you be running, and what is the total wattage? I want to make sure the controller I recommended is properly sized for your setup. Right now, your camper has the Go Power…

view full answer...

Answer 11

It sure can Larry. The Mach-C Everest Variable Speed RV Air Conditioner System item #CM35MR includes an air distribution box that can be used for a top down set up. There's a baffle built into the air distribution box that can be removed to push…

view full answer...

Answer 12

Thanks for the picture! The Optronics Flexible LED Light Strip item #UCL90CB is extremely versatile. It will connect to any 12-volt power source so I am sure whatever power source and switch your lights are currently running off of will work with…

view full answer...

Can The Optronics LED Light Strip # UCL90CB Be Cut In Half?

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching