What is the Adjustable Height Range For The Thule Replacement Support Leg # TH48VK?

Question

Question:

Hello, What is the total adjustable height one can expect from this leg? Thanks

asked by: Dave T

0

Expert Reply:

According to Thule the Replacement Support Leg # TH48VK is adjustable from 4' to 8' in height.

expert reply by: Bud M

0

Answer 1

Hey Cory, thanks for reaching out! The Replacement Support Leg #TH33VK is for the 8-1/2" long Thule HideAway awnings which is what I believe will be a better match than the part #TH48VK you referenced, which is for a 10' long HideAway…

view full answer...

Answer 2

Hey Bill, the Thule Crown awning is a rebranded Hideaway which we have replacement support legs for like with the part #TH33VK. Does your current support leg look like what is in the attached picture?

view full answer...

Answer 3

Hi Josh, The adjustable height is up to 6-1/2 feet for the Replacement Support Leg for Thule HideAway Awnings #TH33VK.

view full answer...

Answer 4

Hey Adam, thanks for reaching out! To remove the old leg so you can install the Replacement Support Leg for Thule HideAway Awnings #TH33VK it looks like you just need to pull back carefully until it releases. I reached out directly to my contact at…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 10

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 11

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 12

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

What is the Adjustable Height Range For The Thule Replacement Support Leg # TH48VK?

Product Page this Question was Asked From

Continue Researching