Will Rapid Hitch Adjustable Aluminum Ball Mount Kit Rattle When Towing

Question

Question:

Does the ball mount “rattle” when installed in the draw bar? It looks as if the round pin holds it in place but if there is clearance it might make noise when towing? I would probably be using this part in its lowest or second to the lowest point for towing an enclosed trailer with under a 2000lb gross weight. Thank You

asked by: Jim G

0

Expert Reply:

There is the potential for noise when using the Rapid Hitch Adjustable Aluminum Ball Mount Kit # AM3417. This is common for adjustable ball mounts since they have several moving parts. If there was no room for movement it would be too difficult to adjust. If you watch the review videos below you can hear the sound from that little bit of play when the ball mount is flipped over. Weight from the trailer will help reduce that unless you're on rough roads. I wouldn't expect it to be any more noticeable than the sounds from the coupler or safety chains rattling around while towing.

expert reply by: Robin H

0

Answer 1

You are correct, the 2 inch diameter ball and the 2-5/16 inch diameter ball that come with the Rapid Hitch Adjustable Aluminum Ball Mount Kit #AM3417 are constructed of aluminum. The cap on the hitch ball is a nylon cap.

view full answer...

Answer 2

Hey Jeff, The specs you are looking for on that B & W tongue weight scale, #BW34KR, are below. Since this is a brand new item from B & W there is no earlier date to get this yet as it is set to release fall of 2025. The over all capacity of…

view full answer...

Answer 3

To find the correct rise or drop what you need to measure is the from the ground to the top of your hitch receiver opening, which it sounds like you have done and got 25-1/2". You also need to measure from the ground to the bottom of the…

view full answer...

Answer 4

When it comes to replacing the Brake Away Cable on The Dexter Brake Actuator #DX29FR The Emergency Break Away Cable Repair Kit for Dexter Axle A-60 Brake Actuators #DX64X is the correct kit for you. . This kit includes the components needed to repair…

view full answer...

Answer 5

In order to add tie-down loops to your Thule TracRac TracVan Ladder Rack #TH29611XT, I recommend the Thule Tie-Downs #TH25100. This kit includes 2 tie-down loops and the needed hardware. The Aluminum Shim Kit #TH29700 that you also referenced is…

view full answer...

Answer 6

It sounds like you're trying to mount a bike rack on your Gen-Y Ball Mount using a hitch adapter on the top receiver with enough clearance to not interfere with your trailer's jack. I'm not going to tell you that you can't do this…

view full answer...

Answer 7

You will first want to check the fuses on your tow vehicle. Some vehicles could have fuses for operating the turn signals and brake lights of a towing package. You will want to check if they are installed and working properly. The next thing is to…

view full answer...

Will Rapid Hitch Adjustable Aluminum Ball Mount Kit Rattle When Towing

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching