Would The HappiJac Electric Truck Camper Jacks Be Used To Lift A 24' Camper Box
Updated 01/22/2024 | Published 01/20/2024
Question:
I have a custom 24ft camper box that is well under the weight rating of these jacks that I need to lift off a flatbed trailer. Can these jacks be mounted on front and back 24ft apart and 8ft apart side to side? Also do the jacks plug together when lifting is needed then disconnect when not needed?
asked by: Jason
Helpful Expert Reply:
The HappiJac Electric Truck Camper Jack System # LC736515-ELKIT comes with two 20' long wire harnesses and two 10' long wire harness which would connect to the jacks and run over to the control module. Depending on where you mount the control module you should be able to get a 24' spacing between the jacks. These jack would have to be hardwired but the connector for the jacks is just a 2-pole connector that can easily be disconnected if needed. As long as you stay under the capacity of the jacks you shouldn't have an issue. Just remember that these jacks are only for lifting and shouldn't be used to fully support the weight of the trailer in storage for a long period of time.
Product Page this Question was Asked From
HappiJac Electric Truck Camper Jack System - 36-1/2" Lift - 11,200 lbs
- Camper Jacks
- Truck Camper
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36-1/2 Inch Lift
- 4 Jacks
- HappiJac
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Vehicle Sway Bars
- Shop: Trailer Wiring
- Shop: Hellwig Adjustable Big Wig Rear Anti-Sway Bar - 1-1/4" Diameter
- Search Results: bottle jacks
- Search Results: rubber bumper
- Shop: Hellwig Adjustable Big Wig Rear Anti-Sway Bar - 1-5/16" Diameter
- Shop: Power Mountain Tallboy Off-Road Bottle Jack - 8-1/2" to 37-3/4" Lift - 6 Tons
- Shop: Hex Drive Drill Adapter for HappiJac Camper Jacks - Qty 1
- Shop: Suspension Enhancement
- Shop: Hellwig Adjustable Big Wig Rear Anti-Sway Bar - 1-5/16" Diameter
- Shop: Hellwig Adjustable Big Wig Rear Anti-Sway Bar - 1-5/16" Diameter
- Search Results: receiver extender
- Search Results: hitch extension
- Search Results: 2 inch ball hitch
- Shop: Power Mountain Tallboy Off-Road Bottle Jack - 7-15/16" to 26-3/4" Lift - 2 Tons
- Video: Curt Trailer Hitch Extension and Reducer Feature Review
- Q&A: What is the Weight of the Happijack Electric Camper Jacks # LC736514-ELKIT?
- Video: An In-Depth Look at the Rubber Bumper
- Video: Comprehensive Review: Rubber Bumper for Enclosed Trailer Ramp Door
- Video: Ultimate Overview of the Curt Hitch Extension and Reducer for 2-1/2" Trailer Hitches
- Video: Comprehensive Review: TorkLift Cannon Hitch Extension for 3" Factory Hitch Receivers
- Q&A: How Much Do the Power Mountain Tallboy Off-Road Bottle Jacks Weigh?
- Search Results: 41157
- Q&A: Happy Jack Extension and Swing Out Brackets for Clearance on a Ford F-450 Cab Chassis w/ Camper
- Video: Dexter Tandem-Axle Trailer Hanger Kit for 2" Slipper Springs: The Breakdown
- Video: Comprehensive Review: HappiJac Extender Bracket for Dual Wheel Chassis Truck Camper Jacks
- Q&A: Parts Needed To Convert Boat Trailer From Single to Tandem Axle Trailer
- Q&A: Number of Axles and Their Effect on Tongue Weight
- Shop: Trailer Hitch
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
on Camper Jacks
