Can a Manual Raise/Lower Trailer Jack Be Converted to Be Used With a Drill
Updated 01/08/2024 | Published 01/06/2024 >
Products Featured in This Question
Question:
I have a square tube side wind jack on my car hauler. Is there a replacement crank pin that converts the jack to use with a drill?
asked by: Mike V
Expert Reply:
The only jack that can be converted to be used with a drill would be the Bulldog single speed jacks with a 12K capacity. If you have this jack then you'd just need the conversion kit # BD1824200100 and the gear kit # BD500212.
Otherwise, you'd need to just replace the jack with one that can be used with a drill like the Trailer Valet JXC Trailer Jack w/ Footplate and Drill Powered Option # TV94FR.
Product Page this Question was Asked From
Replacement Handle Shaft for etrailer and Ram Square, Direct Weld Jacks - 10,000 lbs
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Handles and Cranks
- Handle Rod
- etrailer
more information >
Continue Researching
- Search Results: slide out motor
- Shop: etrailer Manual Sidewind Trailer Jack w/ Drill Adapter - A-Frame - 14" Lift - 2K
- Shop: Lippert In-Wall RV Slide-Out Motor
- Shop: Lippert Replacement 500:1 Motor for Electric In-Wall RV Slide-Out System - High Torque
- Shop: Lippert Replacement Motor with Brake for In-Wall RV Slide-Out - Mid Torque
- Shop: Replacement Handle Shaft for etrailer and Ram Square, Direct Weld Jacks - 10,000 lbs
- Q&A: Tekonsha Brake Controller Wiring Adapter For A 2025 Ram 1500
- Q&A: Converting 18' Flatbed Trailer From Surge Brakes To Electric Over Hydraulic Brakes
- Q&A: Best Lug Nuts for 2021 Keystone Cougar 29RKS
- Q&A: How to Replace Interior Ram Jack Rod and Nut # TJD-12000-RODNUT on 12000 Series Jacks
- Q&A: Repair Kit for Ram Series 12000 Trailer Jack
- Q&A: Do You Have a Hub That Fits LM11949 and LM67048 Bearings?
- Q&A: How To Re-Assemble The RAM TJD-12000SP Trailer Jack
- Article: Trailer Maintenance Schedule
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Measure a Trailer Axle
- Article: How to Install E-Track in 3 Easy Steps
- Article: How to Wire an Electric Winch

