Replacement Frame Only Kwikee 28 Series RV Electric Steps

Question

Question:

When pulling my RV into the driveway - my door somehow opened up and the kwikee electronic step extended out and got jammed in my driveway rock wall bending the frame. The motor and switch are still functional just the step and metal frame are bent. Does Lippert sell LC3747452 with just the frame without the motor?

asked by: Gus L

0

Expert Reply:

A replacement Kwikee 28 Series RV Electric Step (frame only) can be purchased with part # LC3747457. This will be only the steps so you'll have to swap all of the hardware and other components over to these new steps.

expert reply by: Kevin C

0

Answer 1

I spoke with Lippert about the Lippert Components Kwikee Step Frame 28 Series Step part #LC3747457 and unfortunately, they do not provide any mounting information as this is done through the trailer manufacturer. They did however state that you…

view full answer...

Answer 2

Hey Ricardo, Thanks for your question. For the Replacement Step, Motor, and Control for Kwikee RV Electric Steps - 28 Series - 23-5/8" Wide #LC3747452, the replacement motor is #LC379608, and the replacement controller is #LC379146. I noticed…

view full answer...

Answer 3

Hey Aldo, sorry about your troubles, that sounds frustrating for sure. While that is not super common, I've heard of it happening from time to time. Sometimes the manufacturers weld the top of the bolt in place or press it in so that you…

view full answer...

Answer 4

Hi John, From what you're describing and the photo of your switch on the wall it looks like you need the MaxxAir MaxxFan Plus 4-Speed Roof Vent part #MA00-04751KSX. It will work with your original garnish ring in the ceiling and your wall-mounted…

view full answer...

Answer 5

The difference is that the part #LC3747453 comes with the Adapter/Harness #LC369413 and the Switch Magnet #LC369299 while part #LC3747452 does not. Aside from that these are the same step.

view full answer...

Answer 6

The issue you are having your Kwikee Electric Steps could be attributed to a few different issues. The first issue could be that the override switch is not wired properly. I have attached for you below a photo that shows how the steps/switch should…

view full answer...

Answer 7

The correct replacement control module for your Kwikee control module 909506000 is the Replacement Control Unit for Kwikee Electric RV Steps #LC379606.

view full answer...

Answer 8

I wish we did John but your Perimeter View uses different inputs then the wired systems we have available. The closest thing we have to it is the Rear View Safety Backup Camera System item #RVS-062710. It has 2 color backup cameras with a 130°…

view full answer...

Answer 9

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 10

Hey Donny! For your Dometic Penguin/Brisk Air 15,000 BTU AC model B59516.711C0-MX, the correct soft start is the #DMC93JF. This is designed for Dometic Brisk II electronic air conditioner units with in-wall thermostats.

view full answer...

Answer 11

Hey John! You weren't finding that SolidStep because Lippert discontinued it in 2024 and that table wasn't updated to reflect this. What I recommend instead is the MORryde StepAbove RV Steps #MR26RR. These are designed to fit 23-3/4" to…

view full answer...

Answer 12

Appreciate you reaching out Juan! Lippert confirmed that your LCI number is a 1621 pin box. Rota-Flex 5th Wheel Pin Box #LC328330 is going to be a direct replacement and bolts right on. The Rota-Flex pin box is highly rated because it has a pivoting…

view full answer...

Replacement Frame Only Kwikee 28 Series RV Electric Steps

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching