Recommended In Bed 7-Way for a 2024 Ram 2500

Question

Question:

Can I use this wiring harness to have my 7-way inside the truck bed on a 2024 Ram 2500?

asked by: Ramon

0

Expert Reply:

Yes, you can and it'll allow you to keep the one on your bumper. I recommend the Curt 5th Wheel/Gooseneck Custom Wiring Harness w/ 7-Pole Connector item # C56070. This harness puts a 7-way connector in the bed of your 2024 Ram 2500 and makes hooking up to your gooseneck or 5th wheel trailer easier and more convenient.

I have attached a couple of pictures below along with an installation video to help you get this 7-way harness set up and show you what it looks like once installed.

expert reply by: Jerred H

0

2024 Ram 2500
(click to enlarge)

Answer 1

The Bauer Product Door Lock part #BA63FR is the correct replacement for the latch you have on your 1998 Featherlite horse trailer.

view full answer...

Answer 2

The Hopkins Endurance 5th Wheel/Gooseneck 90-Degree Wiring Harness #41157 will allow you to install a 7-Way in the bed of your 2024 Ram 2500. This harness plugs in line of your factory wiring at the bumper 7-way so there is no wire splicing required…

view full answer...

Answer 3

For your 2018 Ford F-150, I recommend the Reese Quick-Install Custom Base Rails and Outboard Installation Kit for 5th Wheel Trailer Hitches #RP56034-53. This will be a custom fit that will allow you to install the brackets without drilling into your…

view full answer...

Answer 4

If you check out the video I attached you can see how 7-way harnesses like the one you referenced disconnect at the rear of them. Right at the 46 second mark you will see the pin that has to get removed.

view full answer...

Answer 5

There is an Andersen Ultimate 5th Wheel Connection that clamps onto a standard 2-5/16 inch gooseneck ball including B&W as well as other brands. We do not currently offer that hitch but we do have something that is better. Take a look at the…

view full answer...

Answer 6

Hey Mark, the only real downside to an offset ball like the Gen-Y part #GY43XR is going to be that it costs more typically and it would take up more room when stored compared to a non-offset ball like the #C38CR. The handling and weight carrying…

view full answer...

Answer 7

Hey Eumir, the 9610007991 Dometic Connect Essential RV Thermostat RV-C #DMC79JF does not have the ability to control the two heat sources independently. It can control both but it does not have ability to pick between either.

view full answer...

Answer 8

Hey David! What you need is the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers - Ram #3024-P. This will fit the brake controller port on your 2025 Ram 1500. Which Tekonsha brake controller do you have and what are you towing?

view full answer...

Answer 9

Hey Nate, We do not have a 3/4" spindle nut or washer, the smallest option is the 7/8" spindle nut #165931and a 1" washer #SW1000. I cannot find anything smaller. Are you sure the threads on you're spindle are 3/4"? If they…

view full answer...

Answer 10

Hey Michael congrats on the new truck! The social media group is 100% correct. Adding a sway bar to the rear of your 2026 Ford F-250 is definitely going to help with sway. However, I've got a better option since you're getting sway going slow…

view full answer...

Answer 11

Hello Chris, Thanks so much for writing in and a double thank you for including the full brake assembly part number. That is incredibly helpful! Since you have the Kodiak Disc Brake Kit 11.35" Rotor #120 Spindle 12K ALKO #K2HR12A11-120DW, you…

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Recommended In Bed 7-Way for a 2024 Ram 2500

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching