Does the LED Trailer Fender Clearance Light MCL180ARB Come with One or Two Lights

Question

Question:

Hello, is the order came in pair or each ?

asked by: Matt

0

Expert Reply:

The LED Trailer Fender Clearance Light # MCL180ARB is a single unit that comes with a single light. It can be used on either the driver or the passenger side though since it has both an amber and a red side to it.

expert reply by: Jon G

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 5

The main difference between the Curt Trailer Hitch Receiver part #C13416 and the EcoHitch Hidden Trailer Hitch Receiver part #EH97FR is that the EcoHitch has a completely hidden cross tube whereas the Curt cross tube will be visible from the rear of…

view full answer...

Answer 6

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 7

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 8

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 9

Hey Adrian! The higher capacity for the B&W #BW47BR and Curt #C77MJ comes from the construction. The B&W hitch weighs 45 lbs and then the Curt and Trailer Mate #TMT54FR both weigh 32 lbs. The Trailer Mate does sit just a tad higher compared…

view full answer...

Answer 10

Hey Aniki, the B and W hitch part #BW47BR has the same ground clearance dimension as the Curt #C77MJ, 12 inches. Are you worried about dragging?

view full answer...

Answer 11

Hi Fred! The safety chain loops on the B&W Trailer Hitch Receiver - Custom Fit - Class III - 2" #BW47BR are a bit different than other hitches, but they are indeed the oval cutouts. They will be slightly more difficult to get to than more…

view full answer...

Does the LED Trailer Fender Clearance Light MCL180ARB Come with One or Two Lights

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching