Replacement Cover for Trailer 4-Way Connector

Question

Question:

I am putting a 4 pin connector on my trailer. where can I get the plastic cover that goes around the wires for protection? The ones on my trailer is in pretty rough shape. Thank You

asked by: Wayne G

0

Expert Reply:

We do have replacement covers for 4-way connectors with the part # C58200.

expert reply by: Jameson C

0

Answer 1

For your Fulton F2 Swing-Up Trailer Jack, Dual 7" Wheels, Sidewind, Bolt-On - 1,600 lbs #F1413020134 part number 9 you referenced is not a replacement option. The outer tube components are not replaceable according to my contact at Fulton. That…

view full answer...

Answer 2

If you had single wire trailer taillights initially that meant that the assemblies grounded through the mounting hardware. If you went to a two wire light that would mean you would actually have to ground each of the assemblies using the white wire…

view full answer...

Answer 3

For a cover designed to fit over standard 4-way connectors we have the #C58200. Another very helpful idea will be to put dielectic grease on the pins of your 4-way. This will actually be your best way to fight the corrosion. For that you would want…

view full answer...

Answer 4

In order to find a replacement side marker light for your 2015 Dynamax Dynaquest I recommend taking some measurements of the current light. There is not a direct replacement available so you will need to find something that is a close match and…

view full answer...

Answer 5

The Wesbar license plate bracket part number 003201 that you referenced is a universal license plate bracket just like the Optronics Trailer License Plate Bracket part #LP15SB. To see if the mounting holes would line up check out the dimension…

view full answer...

Answer 6

Sounds like you are looking for the Curt 4-Way Flat Wiring Connector Cover #C58200 which is a universal style 4-way dust cover that can be closed when not in use to protect the connector.

view full answer...

Answer 7

Instead of cutting off your plug and splicing, I recommend using the Hopkins 4-Pole Loop - 12" Long #HM48145 along with some dielectric grease like the Loctite Bulb, Lamp, and Electrical Connection Dielectric Grease - 0.33-Oz Tube #LT37534 to…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Replacement Cover for Trailer 4-Way Connector

Product Page this Question was Asked From

Continue Researching