Can Curt Replacement Breakaway Switch be Used With RVI

Question

Question:

Is this the correct breakaway switch replacement for the RVI break. The one I have says Curt on it but it does not have a model number.

asked by: Bill M

0

Expert Reply:

Yes, you can use the Replacement Switch for Curt Soft Trac I and II Trailer Breakaway Kits # C52010 with your RVI kit.

expert reply by: Kyle S

0

Answer 1

Roadmasters priority when it comes to their sway bars is top notch quality and the easiest install for the customer. This typically cuts the install time down enough that you end up saving money if you pay to have the bars installed or decide to do…

view full answer...

Answer 2

The Replacement Amber Lens for MC32AB Trailer Lights #A32AB is a direct replacement for the Sae-a-p2-dot-14 that measures 4" L x 2" W x 1/2" H. A red lens replacement with the same dimensions is the LED Trailer Clearance or Side Marker…

view full answer...

Answer 3

I do have a solution for you, however you will not be able to use a pin on your existing 4-Way for a battery charge line.In order to run charge line from the RV to your 2008 Jeep Wrangler battery, I first recommend installing the Roadmaster 6-Wire…

view full answer...

Answer 4

The weight capacity listed for cables is for the pair. For example the Blue Ox 7' Safety Cables - 7,500lbs #BX88196 you referenced would have a 3,750lb capacity per cable. Since Roadmaster doesn't have a 7,500lb cable I'm assuming…

view full answer...

Answer 5

Hey Fred, I checked with Blue Ox just now and our Blue Ox base plate kit part #BLU77ER is a confirmed fit for your 2025 Ford Ranger and would work great. Do you have a Blue Ox tow bar already?

view full answer...

Answer 6

Hey Troy! The reason you aren't seeing a direct replacement is because they're no longer around. Everyone switched to the new R32 refrigerant in 2025 because of the EPA regulations so R410A units are no longer being produced. All of the old…

view full answer...

Answer 7

The Replacement Breakaway System for Brake Buddy Classic and Select Supplemental Braking Systems part #HM39340 replaces the brake away switch for the brake buddy Classic II, Select II, Classic 3 (#HM39494), and Select 3 (#HM39524). We have not yet…

view full answer...

Answer 8

Longer arms will simply place the towed vehicle further back giving you a bit more turning clearance. That being said, the difference is so small you probably wouldn't really see any benefit. When I recommend tow bars, or any other product for…

view full answer...

Answer 9

The Second Vehicle Breakaway Kit for Blue Ox Patriot Supplemental Braking Systems #BRK2505 is designed to work with the Blue Ox Patriot BRK2012 (NLA), Patriot II BRK2010 (NLA), BRK2016 (NLA), or the Patriot 3 BRK2019 (NLA). Unfortunately, this will…

view full answer...

Answer 10

The complete replacement breakaway kit for a Hopkins Brake Buddy II is the part #HM39340 but since you only want the switch Fred and it's a universal switch that is used you could use the part #C52010 and be fine.

view full answer...

Answer 11

Hey Al, thanks for reaching out. We do offer a wiring harness for the 2026 Toyota Corolla Cross Hybrid S. You will just need to select from the following depending if you have LED taillights or not: - Curt T-Connector Vehicle Wiring Harness with…

view full answer...

Answer 12

Hey Karl, a set of 68 inch long safety cables like the part #RM-643 would be what you'd want. There aren't really a whole lot of different length cables for different setups so its best to just go with this set which is what Roadmaster…

view full answer...

Can Curt Replacement Breakaway Switch be Used With RVI

Product Page this Question was Asked From

Continue Researching