Can I Use A Wireless Brake Controller On My 2023 Winnebago Ekko?

Question

Question:

Can I use either the Curt or Tekonsha from wireless from controllers on my 2023 Winnebago Ekko?

asked by: James G

0

Expert Reply:

You certainly can use a wireless brake controller like the Curt Echo wireless # C51180 Or the Echo under dash # C27JR and # C51515. The Curt Echo wireless # C51180 would be a great option if you are having trouble finding your under dash connection.

expert reply by: Jesse M

0

Answer 1

Hey Timothy! The brake controller port on the Sprinter is located under the driver seat. The connector picture below will fit into the port and allow you to install a brake controller like the Redarc Tow-Pro Elite #RED52CR. I also linked an…

view full answer...

Answer 2

I can definitely help set you up. The factory 7 way plug will have 12v power from the factory. There will not be a plug under the dash, but you should have the 4 brake controller wires already present. You just need to purchase a brake controller and…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 6

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 7

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 8

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 9

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 10

Actually, the P3 now has the upgraded axis accelerometer like the P2. The Tekonsha P3 Trailer Brake Controller #90195, will work with both electric over hydraulic brakes on the trailer as well as electric brakes. It has a menu option on the display…

view full answer...

Answer 11

You're right, the mounting bracket is unique (in a good way) for the Curt TriFlex NEXT Trailer Brake Controller #C24VV. The bracket is smaller and all you do is put the included adhesive tape on the bracket and stick it wherever you like under…

view full answer...

Answer 12

Hi Jeff, welcome back and sorry to hear that gave you so much trouble. The Redarc Tow-Pro Link Bluetooth Brake Controller #RED57AR will work on your Silverado. This plugs in-line at the back of your 7-way at the rear of the truck. You can either…

view full answer...

Can I Use A Wireless Brake Controller On My 2023 Winnebago Ekko?

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching