Which Rebuild Kit for Roadmaster Falcon All Terrain Tow Bar

Question

Question:

I dont believe RM910003-55 is the correct rebuild kit for my towbar. Pictures do not match my towbar. Please recheck.

asked by: Terry W

0

Expert Reply:

You are correct, the Roadmaster Falcon All Terrain tow bar repair kit is the part # RM910003-85.

expert reply by: Jameson C

0

Tow Bar
(click to enlarge)

Answer 1

Check out the picture I attached plus the FAQ article to the right to see a 7-way diagram you could use to wire up your trailer.

view full answer...

Answer 2

Hello Tom. It sounds like you are looking for replacement parts for your Roadmaster Falcon 2 Tow bar Part #RM-520. You did not mention what exactly you are looking for, so here is a list of all of the replacement parts we carry for this tow bar: -…

view full answer...

Answer 3

Inspect the inner arms to make sure they aren't bent, but as long as they are straight yes it would be smart to rebuild the arms with the part #RM-910003-55. Based on your serial number you'd also need two of the #RM-200031-00 as well.

view full answer...

Answer 4

Thank you for all of that info! I reached out to my contact at Roadmaster who looked at your serial number and said your tow bar is old enough that if something needs to be replaced then the entire tow bar will need to be replaced. To replace the tow…

view full answer...

Answer 5

On page 9 of the install instructions for the Roadmaster Falcon #RM-522 that are attached to this page you'll see the care and cleaning section. Basically it just details how to clean and lubricate the tow bar using their recommended cleaner part…

view full answer...

Answer 6

I spoke with my Roadmaster representative, and explained the problem you are experiencing. There is not a repair kit available for the problem you describe, but my rep told me that is sounds as if the anvil bolt on the end of the inner arm has come…

view full answer...

Answer 7

When it comes to choosing between the Blue Ox Patriot #BLU37TR and the Brake Buddy Select 3 #HM39524, these systems are extremely similar in their setup and functionality. Both of these systems provide proportional braking in a compact and easy to…

view full answer...

Answer 8

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

view full answer...

Answer 9

Hey Christian, welcome to the world of RV-ing! So in addition to the Roadmaster Nighthawk #RM-676 you're also goin to need: - A baseplate kit, like the Roadmaster Direct-Connect Base Plate Kit #RM-521453-5. These attach to the Jeep itself so you…

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

Hey Steve, thanks for reaching out! The Roadmaster Direct-Connect Base Plate Kit #RM87NQ fits your 2025 Ford Maverick as long as it's the Hybrid model that doesn't have the engine block heater. It doesn't come with the 6-Pin connector,…

view full answer...

Which Rebuild Kit for Roadmaster Falcon All Terrain Tow Bar

Product Page this Question was Asked From

Continue Researching