Can The Tray Be Removed From A MORryde RV Cargo Sliding Tray

Question

Question:

Can the tray be removed leaving the slides?

asked by: Kale

0

Expert Reply:

Yes, the tray portion of the MORryde RV Cargo Sliding Tray # MR64FR can be removed from the tracks.

expert reply by: Kevin C

0

Answer 1

Hey Ken, thanks for reaching out! The Hollywood Racks RV Rider Bike Rack #HLY64FR is going to be your best bet. It weighs in at 63.5 lbs and can carry up to 2 e-bikes at 80 lbs each. The only issue is if your bikes really do weigh over 80 lbs each…

view full answer...

Answer 2

We have just what you need! The replacement motor for your A-300 series Klauber slide out is the part #LC157511. The last 4 digits of the number you listed confirms that you have an A-300 series which is how I know this is the correct replacement.

view full answer...

Answer 3

The Opti-Brite 12V LED RV Dome Light #ILL07COB has 18 gauge wire. Since this only draws .48 of an amp you could easily run three or four with 18 gauge wire as in most cases 18 gauge wire can handle up to 5 amps.

view full answer...

Answer 4

We definitely can help! To add lift to your MORryde RV Cargo Tray #MR63FR, we do have a kit for that. The part you need is the Height Adjustment Kit for MORryde RV Cargo Sliding Trays #MR34VR. With these brackets, you can adjust them to provide you…

view full answer...

Answer 5

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 6

Thanks for the picture! I checked with Progressive Dynamics the replacement power converter you need for your Parallax Series 7300 Model 7345 is the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 45 Amp item #PD4645V.

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 11

Hey Nelson, so you would need two separate systems since a supplemental braking system can only be used with a towed vehicle and a trailer brake controller can only control trailer brakes. Main difference is a supplemental braking system is designed…

view full answer...

Answer 12

Hey Micah! Pacbrake has actually been around for a long time, more than 60 years. We have had customers ask for these air bags in the past, and we've seen them on vehicles coming in. Until now, Firestone has been the go to since their quality is…

view full answer...

Can The Tray Be Removed From A MORryde RV Cargo Sliding Tray

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching