What Info Is Needed to Pick Out Spare Wheel and Tire for Trailer

Question

Question:

Hi - Id like to see about getting a spare tire for my boat trailer. Its a trailer for a small 15’ sailboat. Please let me know what specs you need to determine sizing, etc.

asked by: Ben P

0

Expert Reply:

If you can get me the bolt pattern of the wheel and the tire size that is on the sidewall of the trailer I would be able to let you know what you would need. I attached a help article on determining bolt pattern as well as a link to a page that has all of our wheel and tire combos as well.

expert reply by: Jameson C

0

Answer 1

Hey Cody, The Air Distribution Box #ACDB actually doesn't have a freeze sensor like the #ACRG15 does. This only has a copper wire poking out of the back of the controller as a temperature wire to tell the system to kick according to the…

view full answer...

Answer 2

Thanks for the info you listed. Based on that the correct replacement motor is the part #LC295380.

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 5

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 8

Hi Mark, You shouldn't need to use the Furrion 7-Way Vehicle Power Adapter part #FR87PR because your 2018 Ram 2500 is from the fourth generation of the Ram 2500 before they did the huge overhaul that changed the circuits and resulted in the newer…

view full answer...

Answer 9

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 10

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 11

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

What Info Is Needed to Pick Out Spare Wheel and Tire for Trailer

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching