Recommended Air Bag Kit for a 2013 Toyota Tacoma w/ a 3 Inch Lift

Question

Question:

2013 Tacoma PreRunner with 3inch lift Will this work with lift?

asked by: Gary C

0

Expert Reply:

Yes, it will but you may need a spacer. The reason I say may is most 3" lifts are not 3" in the rear. If your 2013 Toyota Tacoma has less than a 2" lift in the back then all you will need is the Air Lift LoadLifter 5000 Air Helper Springs item # AL49DQ. If it is 2" or more, in the rear end, you will want the Air Lift Universal Air Spring Spacers item # AL52420.

I recommend adding the Air Lift WirelessONE Compressor System item # AL25980 to your truck. This single path onboard compressor will allow you to adjust the PSI in your air bags from your phone.

expert reply by: Jerred H

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

Hey Doug! The Firestone Ride-Rite Air Helper Springs #F35FV are the right kit for your 2026 Ford F-350 FX4 dually. However, you will need to measure to be sure it fits. The distance from the top of your rear axle to the top of the jounce bump stop…

view full answer...

Answer 3

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 4

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 5

Hi Steve, the safest recommendation is to run your ST145/R12 trailer tire at the maximum cold PSI listed on the tire sidewall, even with a 500 lb load. Trailer tires are designed to carry their rated load at the specified pressure, and running them…

view full answer...

Answer 6

Hello Brad, The reason your Tacoma rides rough after installing the LoadLifter 5000 airbags #AL49DQ is because the airbags add a lot of stiffness to your rear suspension, even at the minimum recommended 5 psi. Airbags are designed to support extra…

view full answer...

Answer 7

Hey Andy. To address the sagging you have in your 2023 Toyota Tacoma's rear end. I recommend the Air Lift LoadLifter 5000 Air Helper Springs item #AL49DQ. These work with the 4WD and 2WD models so long as your axle is mounted below the spring…

view full answer...

Answer 8

Hello again Mike, Happy to get you into the right Air Lift set-up for your 2017 Toyota Tacoma. You will need the Air Lift LoadLifter 5000 Air Helper Springs - Rear Axle #AL49DQ for the airbag kit. Not all lift kits provide the same amount of lift, so…

view full answer...

Answer 9

Hey Travis, when installing the Hellwig EZ-990 #HE24FR on your 2021 Toyota Tacoma you would end up replacing the U-bolts of the truck but this kit comes with them so you wouldn't need to source that elsewhere. Are you current U-bolts in good…

view full answer...

Answer 10

Hey George, congrats on the new truck! You are definitely going to need to support the axle when lifting your Silverado with the Pacbrake Alpha HD Pro Air Bag Suspension Kit item #PB25RV. Lifting your truck by the frame will stretch the bags too far…

view full answer...

Answer 11

The Firestone Ride-Rite Air Helper Springs part #F2407 are what I recommend for a 2023 Toyota Tacoma. These feature a simple bolt-on install and will do a great job of helping provide extra support in the rear when towing or hauling. They are also…

view full answer...

Recommended Air Bag Kit for a 2013 Toyota Tacoma w/ a 3 Inch Lift

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching