Does Install of Replacement Return Spring for Power Gear External Spring Jack Require Removing Jack
Published 07/25/2023
Question:
I have a 2000 Fleetwood Bounder 32H with Power-Gear leveling system. I read all the QandAs on replacing the return springs. Would like a little clarification on return spring replacement. First off. Is it required to remove the Jacks from the RV to replace the return springs? Just had the jacks out to rebuild the cylinders. Not wanting to pull them again. Second. Connor L, says Basically, you just need to unscrew the top bolt. Is that the top bolt into the hydraulic cylinder or the top bolt into the spring itself?
asked by: Glenn B
Expert Reply:
As long as you have good enough access to the jack legs you can leave them installed on your trailer when swapping the springs part # LC359434. I'd recommend putting something under the foot when the spring is off.
The top bolt that Conner referred to is the one at the top of the spring and not at the top of the jack.
Product Page this Question was Asked From
Replacement Return Spring Kit for Power Gear External Spring RV Leveling Jacks
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Hardware
- Springs
- Lippert
more information >
Continue Researching
- Video: Review of Lippert Trailer Jack - Camper Jacks - Replacement Spring Kit - LC359434
- Shop: Replacement Return Spring Kit for Power Gear External Spring RV Leveling Jacks
- Shop: Bauer EM RV Entry Door Lock for Motorhomes - Bluetooth - Right Handed
- Shop: Replacement Square, Direct Weld Jack Inner Tube with Spring-Return Drop Leg
- Shop: Replacement Lippert Control Panel with Amp Connector for 4-Point Leveling System
- Q&A: Replacement Return Spring Kit For Lippert Power Gear RV Leveling Jacks
- Q&A: Replacement Spring for Power Gear Jack on 1998 Bounder Fleetwood Motorhome
- Q&A: Do You Have a Power Gear 500385 Replacement Jack?
- Q&A: Replacement Spring for Power Gear External Spring RV Leveling Jacks
- Q&A: Replacement Spring Kit Recommendation for RV Power Gear Jack
- Q&A: Replacement Spring Kit for Power Gear Jack
- Q&A: Can Loop on Power Gear RV Leveling Jacks That Connects to Return Spring Kit be Replaced