How to Measure Width for Replacement Access Tonneau Cover Velcro Strip

Question

Question:

I have a access LiteRider cover. When I measure the velcro do I include the sides that slide into the rail, in that case I need 1 1/2inch or do I just measure the velcro itself in that case its 1 1/4 Im sure it will be 1 1/2inch but just want to be sure. Thanks

asked by: David L

0

Expert Reply:

You'll be measuring the whole width of the Velcro, which includes the part that slides into the rail.

Since yours measures 1-1/2" you'll want to get the 1-1/2" x 17' Replacement Velcro Strip # A30474.

expert reply by: Jon G

0

Answer 1

The correct replacement Velcro for the Access Vanish tonneau covers is part #A60270.

view full answer...

Answer 2

I'm going to need you to measure the width of the Velcro strip of your Access tonneau cover. If the width his 1-1/2 inch you'd need the part #A30474, if it's 1 inch you'd want the part #A60270, or 1-1/4 inch part #A20790.

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

Hello again, Randall, thanks for reaching out. I looked everywhere and I also was not able to find the exact T-slot size listed anywhere. I do know the bars use standard T-slots, so any accessory that is also made for standard T-tracks should work…

view full answer...

Answer 8

Hey Allen, thanks for the information. The best SumoSprings for your 2019 Chevy Silverado 1500 are going to be the 1,500 lbs capacity item #SS45FR. These fit both the 2WD and 4WD models and replace your factory bump stop. The SumoSprings item #SS45FR…

view full answer...

How to Measure Width for Replacement Access Tonneau Cover Velcro Strip

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching