Replacement Trailer Tail Lights For a Wesbar Tail Light 403078

Question

Question:

I am looking for an equivalent replacement for my Wesbar 105826 trailer lights. Hoping to find a replacement with the same mounting bolt locations on the housing.

asked by: Darrell K

0

Expert Reply:

As the Wesbar Lights 403078 are the lights which use the lens 105826 I recommend replacing them with the Optronics LED Combination Trailer Tail Lights # TLL160RK. These lights have a similar mounting pattern which places the bolts on 2" centers and are rated for trailers over 80" wide.

expert reply by: Bud M

0

Answer 1

For an LED replacement that is nearly identical to the Wesbar 105826 light you can use #STL36RB for the right side and #STL37RB for the left side. There are also versions that have a plug instead of just bare wires. For the right side use #STL36RPG…

view full answer...

Answer 2

Kenda trailer tires are primarily made in China like most trailer tires. The only Radial trailer tires that I'm aware of that are made in the United States are the Goodyear Endurance line. Carlisle has a bias ply line of tires made in the States,…

view full answer...

Answer 3

The three radial special trailer (ST) tires we offer in size 215/75-14 can be seen on the linked page. These include the Taskmaster #TTWTRTM2157514D in Load range D, the Provider #TTWTR21514 in Load Range C and the Kenda Karrier #AM10229 also in Load…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 7

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 11

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 12

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Replacement Trailer Tail Lights For a Wesbar Tail Light 403078

Product Page this Question was Asked From

Continue Researching