Will Fastway e2 Spring Bars Fit a Reese Pro Round Bar Weight Distribution Hitch?

Question

Question:

Will the e2 round bar work with the reese 49912 hitch?

asked by: Chad

0

Expert Reply:

Only the Reese spring bars will fit in their Reese Pro Round Bar Weight Distribution # RE94FR. I recommend changing to the Fastway e2 Weight Distribution # FA92-00-0800 which I feel is a far superior system. This hitch uses trunnion bars which are held in by pins and clips. The Reese an other round bar systems use spring clips to hold in their round bars. I have seen these fail several times and the spring bar becomes lost with not replacement available.

expert reply by: Bud M

0

Answer 1

Hey Mike, so a friction sway control unit like the part #83660 can help stop some of the sway that starts from wind or passing semis but if you are experiencing persistent sway once you hit a certain speed that will only be fixed by increasing the…

view full answer...

Answer 2

The main reason for the price difference is the different construction used for the weight distribution hitches. The Reese Weight Distribution System #RP66540 uses mostly cast parts that are more expensive to manufacture. While the Reese Pro Round…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 6

To install a Redarc Tow Pro Liberty in your 2023 Toyota Tacoma Sport you will need the following parts: Redarc Tow-Pro Liberty Brake Controller item #RED24FR Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item #RED99FR…

view full answer...

Answer 7

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 8

Hey Michelle! There are definitely a lot of different weight distribution hitch (WDH) options out there. The most important thing is to make sure it is properly rated for the tongue weight of your setup. Looking at the specs for the 2022 Keystone…

view full answer...

Answer 9

Thanks for letting us help John. First off, congratulations on the new truck and trailer! We can definitely help you get everything set up for towing. For the brake controller, I'd recommend the Redarc Tow-Pro Liberty Brake Controller with Custom…

view full answer...

Answer 10

Hey Roger, thanks for reaching out, and congrats on the new camper! For your Silverado and No-Bo 18.2 BeastMode, I really like the Fastway e2 setup. Here is what I recommend: - Fastway e2 Weight Distribution Hitch w/ 2-Point Sway Control - 10,000 lbs…

view full answer...

Will Fastway e2 Spring Bars Fit a Reese Pro Round Bar Weight Distribution Hitch?

Products Featured in This Question

Continue Researching