Mounting Plate Dimensions And Bolt Hole Spacing On The Ultimate Trailer Jack 322-RDJ-2K

Updated 07/17/2023 | Published 07/15/2023

Products Featured in This Question

Ultimate Trailer Jack - A-Frame - Topwind - 27-1/2" Lift - 2,000 lbs

(802)

$83.26

Question:

I have a RAM jack 3000lb support/2000lb jacking my Homesteader trailer. Will this jack replace it as far as the mounting hole placement or, if available, is there a template of the jack mounting hole pattern that you can send me.

asked by: Stuart S

Expert Reply:

Yes you can absolutely use the ultimate trailer jack # 322-RDJ-2K to replace an older ram jack. The dimensions for the mounting plate are standard and should be the same.

The bolt holes are oval slots each having a 3 inch on center measurement. They range from 2-5/8 to 3-5/8 inches from the front of the coupler back and then the side to side holes range between 2-3/8 inches to 3-7/8 inches.

The overall plate dimensions are 4-7/8 inches on the back and 4-5/8 inches on the sides from the coupler back. I've attached a photo to assist.

expert reply by: Jesse M