Replacement Key For A Global Link Entry Door Lock G316 Keycode

Question

Question:

I have a Leonard enclosed trailer and the key is lost. On the inside lock is the Code G 316. Is it possible to get a key for this

asked by: Garry W

0

Expert Reply:

Since your keycode starts with "G" you most likely have a Global Link entry door lock, which would mean the correct replacement key for that code would be part # 295-000042.

expert reply by: Kevin C

0

Answer 1

Hi Jeff, What you have there is a Fastec (FIC) entry door latch on your trailer, and the good news is we can get you a replacement with the following: - Global Link RV Entry Door Locking Latch Kit #295-000019

view full answer...

Answer 2

I recommend taking a look at the Taskmaster ST205/75R14 Radial Trailer Tire #TR20514. This is a great radial tire with a maximum load of 1,760 pounds at 50 psi. It has an excellent maximum speed of 81 mph and a 6 ply rating and also includes a 2-year…

view full answer...

Answer 3

The Camco Olympian Wave 3 Catalytic Safety Heater for Small RVs #CAM57331 that you referenced does require a window be cracked in the RV when being used so that the catalytic combustion has enough fresh air for completion. If you check out the review…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 6

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 7

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 8

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 11

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 12

The BTR and BT8 denotations refer to the spindle, not the trailer hub. The difference between a BTR and BT8 spindle is that the BTR spindle uses a 1.063" diameter L44649 bearing and the BT8 spindle uses a 0.99" diameter L44643 bearing. In…

view full answer...

Replacement Key For A Global Link Entry Door Lock G316 Keycode

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching