Replacement Inner and Outer Foot Pads for Malone AirFlow2 Roof Rack Feet

Question

Question:

Malone AirFlow2 Roof Rack So you sell any of the rubber replacement peices. i lost 2 of smaller the rubbber mounts that go on the moveable part of the mount

asked by: Dan R

1

Helpful Expert Reply:

We do have the replacement rubber pieces for the feet on the Malone AirFlow2 Roof Racks, like part # MPG215. Here are the parts you're looking for:

- Inner Foot Pad # MAL47AR
- Outer Foot Pad # MAL67AR

expert reply by: Jon G

1

Answer 1

I checked with Rhino-Rack and the capacity of the Nautic kayak carrier #RR571 is dependent on the capacity of the roof rack on the vehicle. If your roof rack can support 75 pounds then that is what the carrier would be rated for. The carrier itself…

view full answer...

Answer 2

The Malone #MPG216 AirFlow 2 roof rack is what I'd refer to as a budget-priced product. The quality is pretty decent, but they don't quite reach the Yakima/Thule pinnacle. If the roof rack will see daily or weekly use, it wouldn't be what…

view full answer...

Answer 3

Hello Alex, Great question. I attached an image for reference, since your Rav4 has the factory raised rails you are going to want the Malone SteelTop Roof Rack - Square Crossbars - Raised, Factory Side Rails - Steel - 58" Long #MPG202. If you…

view full answer...

Answer 4

Yes, you can damage the feet on the Malone AirFlow2 Roof Rack part #MPG216 while installing it on your 2016 Nissan Pathfinder. I called my contact at Malone and they stated that their is not a specific increment or torque spec that will need to be…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

The main difference between the Curt Trailer Hitch Receiver part #C13416 and the EcoHitch Hidden Trailer Hitch Receiver part #EH97FR is that the EcoHitch has a completely hidden cross tube whereas the Curt cross tube will be visible from the rear of…

view full answer...

Answer 8

Hi David! There are quite a few hitches offered for your 2026 Honda Odyssey, so I definitely understand wanting to know the differences. There are basically three styles available for you and I have them broken out below: Exposed Crosstube: etrailer…

view full answer...

Answer 9

Hey Ricardo! Yes, the Curt Trailer Hitch Receiver #C82RJ is the hitch Curt is working on for the new 2027 Telluride. This is a pre-order since Curt hasn't finished the design. It does not include wiring. The wiring harness for the 2027 is also up…

view full answer...

Answer 10

Hey Jason, whenever available I would recommend going with the channel attachment for roof rack accessories including the Thule Hullavator part #TH898 as its simpler stronger, and it's basically the future of most roof rack accessories as it…

view full answer...

Answer 11

Hello John, thanks for reaching out. Yes, we do have a Thule roof rack that will allow you to install the Hullavator #TH898 on your 2015 Subaru Forester. For that I recommend the following: - Thule WingBar Evo Roof Rack for Raised Rails - Aluminum -…

view full answer...

Answer 12

It sure is Doug and congrats on your new truck! The TruXedo Pro X15 Soft Tonneau Cover item #TX33TV has been confirmed to fit your new 2026 Ford Maverick. The TS Rails item #TH25FR are going to fit alongside the rails of the Pro X15 item #TX33TV on…

view full answer...