Xtreme Ark Off Road Trailer Jack that Can be Used on Trailer Frame with 19 inch Above Ground

Question

Question:

Hi Will this go high enough for my trailer? The bottom of the tongue frame is 19” Item # ORJW350D

asked by: David G

0

Expert Reply:

The Ark jack you referenced would not go up high enough for the height of your trailer but we do have the similar Ark jack part # ORJW750BD that can go up several inches taller and would work for you.

expert reply by: Jameson C

0

Answer 1

I was able to get the following image information from ARK for their Xtreme Off-Road Swivel Trailer Jack #ORJW750BD which shows the different lengths for the jack in the storage position depending on which setting you have it in. The overall length…

view full answer...

Answer 2

Yes, the ARK Extreme Off-Road Trailer Jack w/ Dual Wheels #ORJW750BD can easily fit and work with a trailer frame that sits 23" off of the ground. In the attached photo the bottom of the trailer frame sits 19" above the ground and the jack…

view full answer...

Answer 3

The Xtreme Off-Road Swing-Up Jack w/ Dual Wheels #ORJW500D and #ORJW350D are pretty similar with the only differences being the weight capacity, 1,100 lbs vs 770 lbs, and the total travel, 18-3/8" vs 12". Aside from that the mounting…

view full answer...

Answer 4

When folded up and traveling the Xtreme Off-Road Ratcheting Trailer Jack item #ORJW750BD is 29" long from the top of the jack to the bottom of the wheels. From the bottom of the wheel to the center pivot point where the bracket attaches is…

view full answer...

Answer 5

The CE Smith Boat Trailer #CE48810 is a great choice to transport your Sun Dolphin Pro and using a trailer dolly will absolutely work for you. You could use the Rack'Em Trailer Dolly #RA20 if you wanted as the tongue weight of your trailer will…

view full answer...

Answer 6

If the pneumatic tires on your Trailer Valet #STC-V211 are needing to be aired up each time you use your trailer I suggest either using a tire sealer product like Slime Tire Sealant #SLM10007 or if that does not solve the issue replacing your…

view full answer...

Answer 7

Here is an image I have from the Xtreme Off-Road Swing-Up Trailer Jack #ORJW750D in zinc which will have the same dimensions as the black Jack #ORJW750BD you are looking at.

view full answer...

Answer 8

Technically if your trailer has a tongue weight (TW) of 500 lbs then it falls into the 500 lb max TW rating of the Trailer Valet 5X Swivel Jack and Trailer Mover #STC-V211. The only problem that I see is that you are at the max capacity of this jack…

view full answer...

Answer 9

Hey Brandon, I would strongly recommend sticking with the Tekonsha RF brake controller part #TK94FR. We know this works really well and it sounds like it worked well for you too. The Curt Echo is not reliable enough for me to really ever recommend it…

view full answer...

Answer 10

The long brackets of the Removable Extreme Off-Road Swing-Up Trailer Jack #ARK57FR that mount on inside of trailer frame are little misleading since they are much taller than the bracket on the other side of the jack that it attaches to. Basically…

view full answer...

Answer 11

I found some photos of a Brenderup Horse Trailer online. It looks to use a unique jack, one I am not sure we have an exact replacement for. That said, I have attached for you below all of our side frame mounted jacks with a bolt-on install which you…

view full answer...

Answer 12

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Xtreme Ark Off Road Trailer Jack that Can be Used on Trailer Frame with 19 inch Above Ground

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching