Will Trailer Idler Hub Assembly for 2,000-lb Axles Fit Log Splitter
Updated 05/23/2023 | Published 05/21/2023
Products Featured in This Question
Question:
Hi team - I have a log splitter with 1 straight spindles that measure 3-3/8 long plus 1 of threads for a total length of 4-3/8. Will AKIHUB-440-2-G-EZ-1K work with this spindle and allow the castle nut to tighten down enough such that the cotter pin will make it thru?
asked by: Brian
Expert Reply:
The Trailer Idler Hub Assembly for 2,000-lb Axles # AKIHUB-440-2-G-1K will fit the spindles on your log splitter, and allow you to tighten down the castle nut so your cotter pin fits. These use # L44643 bearings with a 1" inner diameter and have a 4 on 4 bolt pattern. If you need 5 on 4-1/2 instead you can use the # AKIHUB-545-2-G-EZ-1K.
Product Page this Question was Asked From
Trailer Idler Hub Assembly for 2,000-lb Axles - 4 on 4 - Galvanized
- Trailer Hubs and Drums
- Idler Hub
- Standard
- L44643 / L44643
- Marine Grade
- For 2000 lbs Axles
- 1/2 Inch Stud
- 4 on 4 Inch
- 8 Inch Wheel
- 10 Inch Wheel
- 12 Inch Wheel
- 13 Inch Wheel
- 14 Inch Wheel
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Looking for Hub for 1999 Jayco Qwest 10
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: Should There Be a Washer Between Outer Bearing and Castle Nut on etrailer 2,000 lb Trailer Axle
- Q&A: How to Tell if Trailer has a BT8 or BTR Spindle Installed
- Q&A: 4.80R12 Tire Mounted On Wheel
- Q&A: What Is The Smallest Available Spindle Nut For 2.5k Axle?
- Q&A: What Leaf Spring Should Be Used With 2,000 lb Axle?
- Q&A: What is Difference Between Trailer Bearings L44649 vs L44643
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Trailer Tire Sizing
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: How to Measure a Trailer Axle
- Article: Most Popular Wheel Bearings
- Article: How To Measure And Replace Everything In Your Hub Assembly