Overall Width of MORryde RV Cargo Sliding Tray - 72" x 20"

Question

Question:

The the floor space opening between my cabinets is exactly 20inch wide. I understand the tray is 19.74inch wide, but what is the units total width, including any installation hardware?

asked by: Keith F

0

Expert Reply:

The overall width of the MORryde RV Cargo Sliding Tray - 72" x 20" - 2 Way Slide - 80 Percent Extension - 500 lbs part # MR74FR is 19.74" which is measured from the outside of each rail on either side. The tray width is only 16.85".

I have attached a photo below for clarification.

expert reply by: Conner L

0

Overall Width of MORryde RV Cargo Sliding Tray - 72" x 20"
(click to enlarge)

Answer 1

The best chock/leveling system we have for your motorhome with a dually axle is the Andersen Camper Wheel Chock and Leveler part #AM3604. This system can be used on trailers/vehicles up to 30,000 lbs with wheels up to 32" diameter. They are made…

view full answer...

Answer 2

The actual outside width measurement of the MORryde Sliding Tray for RV Cargo Compartment - 72" x 20" x 6-5/8", #MR74FR, is 19.74". It has an interior measurement of 16.85".

view full answer...

Answer 3

While I can't tell you what that would be as this would vary from RV to RV, however I can tell you that the MORryde RV Cargo Sliding Tray - 72" x 20" - 2 Way Slide #MR74FR has an overall height of 6-5/8". So you'd have to…

view full answer...

Answer 4

From the carpeted "floor" to the top of the railing on the 90" x 26" MORryde RV Cargo Sliding Tray #MR87FR measures 3-1/2" (see attached). If you jump to the 3 minute mark of the linked review video you can see where we take…

view full answer...

Answer 5

Hey Jeff. There is definitely a correlation between weight and capacity. I've listed the weight of all three of the Power Mountain Tallboy Off-Road Bottle Jacks we have below: Power Mountain Tallboy Off-Road Bottle Jack - 7-15/16" to…

view full answer...

Answer 6

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 7

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 8

Hi Chuck! The MORryde RV Cargo Slide Tray - 72" x 26" - 1 Way Slide - 60 Percent Extension - 800 lbs #MR67FR sits 1.6 inches above the floor you mount it on. If you want or need it to be a bit higher off the floor, you can also grab the…

view full answer...

Answer 9

Hi Glen, It will depend on what the GVWR (gross vehicle weight rating) is of your trailer to determine which B&W 5th wheel to gooseneck adapter will work best for you. Fifth wheels and gooseneck trailers go off of pin weight instead of tongue…

view full answer...

Answer 10

Hello again Bob, On the MORryde RV Cargo Slide Tray - 90" x 29" - 2 Way Slide - 60 Percent Extension - 800 lbs #MR69FR the overall dimensions are 90" long x 29" wide x 6-5/8" tall, the actual tray dimensions are 88-1/4"…

view full answer...

Answer 11

So long as your 2005 Jayco has tandem #12 Dexter Torflex axles that are mounted on the side you can use the Torflex Lift Kit - Tandem Axle #K71-725-02. We don't have any way of knowing what is on your trailer but if you take a quick peek at the…

view full answer...

Answer 12

If you have a #10 Torflex axle on your trailer the correct lift is the part #K71-707-01 which will give you 2-5/8 inches of additional lift. Does your trailer frame have the vertical brackets for the side mount like what you see in the picture? You…

view full answer...

Overall Width of MORryde RV Cargo Sliding Tray - 72" x 20"

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching