Hitch Pin/Lock Needed For Demco Channel Tongue Trailer Coupler # DM15931-95

Question

Question:

Will this work with a Demco Item # DM15931-95. Or does the Demco even need a couple pin? Thank you

asked by: Brad

0

Expert Reply:

For the Demco Channel Tongue Trailer Coupler # DM15931-95 you will need the Coupler Pin # 37201281 to ensure the hitch ball does not come unlatched while towing. You can also use the Lock # e98888 for additional security. The Pin # 37201244 you found only has a usable length of 2-9/16" and you need a minimum of 3" to fit your coupler. Also with the coupler pin opening of 5/16" you will not want to use a 5/16" pin as the pin is more likely to get stuck due to corrosion.

expert reply by: Bud M

0

Answer 1

I recommend any trailer with a tandem axle setup use an equalizer regardless of the amount of leaves in the spring or if it is a double eye or slipper spring design. On a system like your trailer where each axle is mounted individually and not…

view full answer...

Answer 2

We do offer a wide variety of replacement lights for trailer but since trailer manufacturers don't keep a record of what they use on trailers I would need some pictures of the lights you are wanting to replace along with some measurements so I…

view full answer...

Answer 3

Hey Brent, what you are looking for is the usable width of the Coupler Pin part #37201281 that you referenced which is 3 inches. This is the distance between the shoulder of the head of the clamp out to where the metal clip slips over the shank. This…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 6

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 7

You can use leaf springs that are rated higher than the axle without any issues as long as they measure the correct measurement for your trailer. For example the 6-leaf double eye spring for 7,000 lb axles part #e64SR measures 24-7/8" eye to…

view full answer...

Answer 8

First I want to make sure you verify your channel mount for the Demco Trailer Coupler #DM14040-81 has a 21K or larger capacity as often times they are less like the Demco #DM15349-52 which often times people look at and think it is a channel mount…

view full answer...

Answer 9

Hey Kris, the Dutton Lainson winch part #DL15440 does not come with a strap so you will need to order one with it. The part #DL24250 will work great with this winch as it is correct width, is 25 feet in length, and has a capacity of 3,700 lb WLL and…

view full answer...

Hitch Pin/Lock Needed For Demco Channel Tongue Trailer Coupler # DM15931-95

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching