Comparing Voyager WiSight 2.0 Wireless RV Backup Camera System w/ Night Vision Part Numbers  

Yes, the Voyager WiSight RV Observation Camera - Wireless item #WVH100 is compatible with your Voyager WVOS541 System. The camera is sold separately. If you are wanting to replace the Voyager Monitor down the road it is item #VOM719WP.

The pre-wiring of Furrion pre-wired RVs is basically just two wires as well as the Voyager harness like part #PSVCWVCMS130AP. One wire is the power wire which is the running light circuit and then the other is the ground so it really would just be…

Unfortunately the Monitor WVOM541 for your WVHS541 has been discontinued and is no longer available. You will need to replace your entire camera and monitor with the Voyager WiSight 2.0 Wireless RV Backup Camera System #ASA57YR. The new monitor and…

To connect back up lights you need to have a 7-way trailer connector on both your trailer and tow vehicle. On a 7-way the reverse lights are powered by the center pin. To connect reverse lights to the trailer's 7-way you can use 16 gauge…

We do have a solution for you, however, you will not be able to power reverse lights on a trailer with a 4-pin trailer connector. The reverse lights on a trailer must receive power from the reverse lights on the tow vehicle. To do this, you will want…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

Since your current camera only says Voyager that means it is going to be the 1st generation. The WiSight 2.0 Camera #ASA74YR has Voyager 2.0 on the camera. So you are going want a new system with either the 4.3" Monitor #ASA24YR or 7"…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…