Replacement Trailer Jack for 2002 Shelby Boat Trailer with Single Bolt Installation

Updated 01/02/2023 | Published 12/31/2022

Products Featured in This Question

Fulton Boat Trailer Jack w/ Wheel - Sidewind - Swivel - 10" Lift - Zinc - 1.2K

(1744)

$86.00

Replacement Bolt-On Mounting Kit for Fulton XP Series Jacks

(38)

$27.87

Question:

I have a 2002 Shelby boat trailer jack that doesn’t have a part number on it It just says Shelby industries and says it is rated for 1000 lbs. It has a single bolt that holds the Jack onto the frame. Not the snap ring set up. The boat trailer has a 19 foot Lund boat on it. My trailer Jack has fallen apart the wheel shaft came completely out. What Jack do you have that will work for this set up.

asked by: Bob H

Helpful Expert Reply:

It sounds like you're needing a jack like the Fulton Bolt-Thru Swivel Marine Jack # FXP10W0301 which installs on trailers that already have the mount welded on with a single bolt attachment for the jack itself (like what we see with part # F500349). The head of the bolt should be welded onto the jack you just just have to remove the nut and washer to remove the old jack, and then reverse the steps to install this new one.

Attached is a review video for you to check out!

expert reply by: Jon G