Dolly Tow or Flat Towing a 2017 Jeep Wrangler Unlimited Rubicon Edition

Published 12/04/2022

Products Featured in This Question

Blue Ox Patriot Portable Flat Tow Brake System - Proportional

(396)

$1482.94

etrailer SD Non-Binding Tow Bar - RV Mount - 2" Hitch - 6,000 lbs

(304)

$819.77

etrailer Classic Base Plate Kit - Fixed Arms

(42)

$401.83

Roadmaster 4-Diode Universal Wiring Kit for Towed Vehicles - 7-Way to 6-Way Coiled Adapter Cord

(3183)

$179.84

Roadmaster Battery Charge Line Kit for Towed Vehicles

(1197)

$45.63

RoadMaster 68" Single Hook, Coiled Safety Cables - 6,000 lbs

(653)

$71.02

Question:

Looking for a tow dolly to tow our 2017 Jeep Rubicon Unlimited jku.thanks

asked by: Dan

Expert Reply:

I have a great flat towing set up for you but dolly towing your 2017 Jeep Rubicon Unlimited is a no go due to the transfer case and that is directly from the Jeep manual itself. According to the manufacturer you can not dolly tow a 2017 Jeep Wrangler Unlimited.

If you are going to use a tow dolly like item # DM9713093 you have to disconnect the rear driveshaft. The rotation of the front driveshaft is what helps pump the fluid through the transfer case. If the rear is spinning and the front is not the transfer case can over heat and cause damage.

To flat tow your 2017 Jeep Wrangler Unlimited Rubicon model you will need a tow bar, base plate, wiring harness, supplemental braking system, charge line, and a high low adapter. I have listed the parts below along with any available installation videos.

Tow Bar - etrailer SD Non-Binding Tow Bar - RV Mount - 2" Hitch - 6,000 lbs item # e34ZR

Base Plate Kit - etrailer Classic Base Plate Kit - Fixed Arms item # e98947. It does not fit the models with an American Expedition Vehicles bumper.

Wiring Harness - Roadmaster Diode 7-Wire to 6-Wire Flexo-Coil Wiring Kit item # RM-15267

Supplemental Braking System - Blue Ox Patriot Radio Frequency, Portable Braking System item # BLU37TR

Charge Line - Roadmaster Battery Charge Line Kit for Towed Vehicles item # RM-156-25

High Low Adapter - The tow bar needs to be within 3" of level. If you measure the height of the inside top of the hitch receiver tube on your RV, and the height difference is more than 3 inches above/below the base plate tab height, you'll need a high/low adapter. I have linked a FAQ article that explains all this in more detail along with our selection of adapters.