Parts Needed To Swap A 7-way To 6-Way Setup To A Magnetic 7-way Setup

Published 11/30/2022

Products Featured in This Question

Roadmaster Nighthawk All-Terrain Tow Bar w/ LED Lights - Non-Binding - RV Mount - 8,000 lbs

(803)

$1545.00

EZ Connector Magnetic 7-Way Trailer Connector with Watertight Seal - Hardwire - Vehicle End

(11)

$72.31

EZ Connector Magnetic Extension Cord w/ 7-Way Trailer Connectors - Watertight Seal - 6' Long

(4)

$149.34

EZ Connector Mounting Bracket for 7-Way Trailer Connector - Vehicle End

(16)

$21.78

Deka Heat Shrink Butt Connector - 16-14 Gauge - Nylon Insulation - Blue - Qty 10

(1110)

$15.88

Question:

Thanks! I think my mount on the RV will work with the magnetic connector but I’ll need a new one for my Jeep. What mounting bracket is recommended?

asked by: Brian D

Expert Reply:

To use a magnetic connector you would need to replace the 7-way on the rear of your motorhome with the EZ Connector Magnetic 7-Way Trailer Connector # 319-S7-05. You would also install a second # 319-S7-05 on the front of your Jeep and use the EZ Connector Magnetic Extension Cord # 319-S7-26 to go between the vehicle and motorhome.

You'll need to make sure that you wire both sockets the same so that each signal properly transfers through. I recommend using some heat shrink butt connectors # DW05744-10 for your wiring to ensure a waterproof connection.

You'll want to remove the cable included with the Roadmaster Nighthawk All Terrain # RM-676 since it will no longer be needed. The cable for the # 319-S7-26 is coiled so you most likely won't be able to get it to pass back through the loops that hold the cable on the NIghthawk.

expert reply by: Kevin C

Brian

11/30/2022

Thanks! I think my mount on the RV will work with the magnetic connector but I’ll need a new one for my Jeep. What mounting bracket is recommended?

Kevin C.

11/30/2022

To mount both 7-way sockets # 319-S7-05 to you vehicle and motorhome I recommend the EZ Connector Mounting Bracket # 319-S7-61. These brackets have pre-drilled holes to allow you to mount the bracket up. These brackets are typically mounted to either the baseplate or directly onto the fascia of the vehicle. A lot of times you can also hide it in the grill of your vehicle by trimming out some of the plastic.