How Many Turns Does it Take to Raise Dutton-Lainson Drop Leg Jack- 2,000 lbs 1 Inch  

A weld-on pipe mount is not included or available for the Trailer Valet JXS Trailer Jack w/ Footplate and Drill Powered Option - Side Mount - Sidewind - 2K #TV34FR. There isn't an option to weld on the Trailer Valet jacks, and the only…

The best solution for raising the trailer tongue would be a base pad/jack stand like the #SC86MR. Raising the ground up with something like this is typically better than trying to extend the jack. Two of these stacked together would give you an…

Assuming you are using a floor jack to raise the trailer and then use jack stands, such as #PTW41021 for a pair, then you could store the trailer that way. A jack itself should not be used to hold a load for extended periods of time.

You can use the Trailer Valet JXS part #TV64FR on an I-beam trailer frame but it would need to fit around the I-beam instead of fitting into it.

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6-1/2 inch whereas the 225/75-15 fits widths that are 5 inch to 6 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

Thanks for the information and photo, Kenneth! It looks like your trailer is equipped with 3,500 lb axles so to replace your bearings and seals you need the kit #BK2-100, but it also looks like you have an older disc brake kit with a design that…

Yes, the DeeMaxx Disc Brake Kit #DE66YR will allow you to use 14" trailer wheels.