Troubleshooting Beeping Every 40 Seconds with Atwood RV Carbon Monoxide Detector

Question

Question:

I have a beeping every 49 seconds, carbon monoxide detector has been disconnected for 3 years. The battery says it is fully charged. The camper is hooked to 110 at the house.

asked by: Linda

0

Expert Reply:

We've seen this issue before on your Atwood RV Carbon Monoxide and Propane Gas Detector # AT36681 and the beeping every 40 seconds indicates "a fault has been detected that compromises some detector function."

What you need to do is use push the Alarm Reset button to attempt to clear the fault. If this does not work, the owner's manual states that "the detector is not functioning properly and must be replaced."

expert reply by: Jameson C

0

Answer 1

Hey Leslie, I checked your part number and what you have is the Dometic Brisk Air II so the correct replacement shroud would be the part #DMC46FR. Did your current shroud get damaged?

view full answer...

Answer 2

Hey Piotr, thanks for reaching out! The weight ratings between the Curt Trailer Hitch Receiver #C94WR and Towsmart Trailer Hitch Receiver #TS96VR that fit your 2025 Kia Sportage are determined by the testing done according to those manufacturers. I…

view full answer...

Answer 3

We've seen this issue before on your Atwood RV Carbon Monoxide and Propane Gas Detector #AT36681 and the beeping every 40 seconds indicates "a fault has been detected that compromises some detector function." What you need to do is use…

view full answer...

Answer 4

On your Atwood RV Carbon Monoxide and Propane Gas Detector #AT36681 there is a circle Reset/Test button on the top right hand corner of the unit. Simply pressing this button should reset the detector and silence any alarms assuming there isn't an…

view full answer...

Answer 5

If your carbon monoxide detector is beeping frequently then it's alerting you that it's time to replace it. It is hardwired to the battery so the only option is to trash it and replace it with another one like the Atwood RV Carbon Monoxide…

view full answer...

Answer 6

If the Atwood RV Carbon Monoxide and Propane Gas Detector part #AT36681 continues to beep even after a rest then this can be narrowed down to either a leak or faulty detector. If you shut off the gas supply to the trailer entirely and the alarm still…

view full answer...

Answer 7

The closest replacement an Atwood PPOO224730 33535E propane detector is the RV Propane Gas Detector - 12 Volt - 2 Wire - Black item #RS44FR. It only uses one power wire instead of two so it is slightly different. It measures 4-1/4" long x…

view full answer...

Answer 8

You could use the 2-wire Propane Gas and Carbon Monoxide Detector part #RS34FR in place of the Atwood 36681 that you referenced. This would fit in the cut out you have now and has a flange that is large enough that would cover the hole.

view full answer...

Answer 9

When replacing your existing detector with the Atwood RV Carbon Monoxide and Propane Gas Detector #AT36681 you will not need to disconnect the 12V trailer batteries. It also does not matter which of the two power wires you connect first. The third…

view full answer...

Answer 10

The instructions state the rest/test button of the Atwood RV Carbon Monoxide and Propane Gas Detector - 12 Volt - White #AT36681 is the button on the top right, and you need to press that in and hold it down. If the rest does not work and the red…

view full answer...

Answer 11

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Troubleshooting Beeping Every 40 Seconds with Atwood RV Carbon Monoxide Detector

Continue Researching