How are the Lippert Replacement Kwikee Steps Extended for Install

Question

Question:

How do i extend steps open for new installation

asked by: Randy R

0

Expert Reply:

You'll need to use a jumper wire to put power and ground on the motor wires of the Replacement Steps, Motor, and Control for Kwikee RV Electric Steps # LC3725791 which will extend them so you can install the setup.

expert reply by: Jameson C

0

Answer 1

Possibly. It completely depends on what steps your Winnebago has and I have no way of knowing this. The Replacement Motor for Kwikee Revolution Series Electric RV Steps item #LC380073 is for the Revolution Series steps like item #LC3725791. I would…

view full answer...

Answer 2

I spoke to my Lippert contact and they informed me that the mounting width of the #LC3725791 is 24-5/8 inches center on center and 25-9/16 inches over all. I have attached an image of the mounting holes for you to check out. The width of the step is…

view full answer...

Answer 3

Hey Andrew, the only solution for what you have is the part #LC3725791 which does come with more than what you need but there isn't just a bare frame like you mentioned.

view full answer...

Answer 4

The Replacement Steps, Motor, and Control for Kwikee RV Electric Steps part #LC3725791 seems to be a suitable replacement for the motorhome. The actual steps measure 23-3/8" wide x 8" deep and the mounting plate bolt pattern measures…

view full answer...

Answer 5

Hey Ed, thanks for reaching out! The Fastway e2 Weight Distribution w/ 2-Point Sway Control #FA94-00-1061 will be too much for your trailer if the 412 lb weight rating you mentioned is with everything fully loaded. If that's the dry tongue…

view full answer...

Answer 6

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 7

Hey Donny! For your Dometic Penguin/Brisk Air 15,000 BTU AC model B59516.711C0-MX, the correct soft start is the #DMC93JF. This is designed for Dometic Brisk II electronic air conditioner units with in-wall thermostats.

view full answer...

Answer 8

That’s a great question Chadwick, and this is one of those situations where the change in technology really matters. The GE Appliances Low-Profile RV AC w/ Heat Pump part #GE26RR will replace your current ARC13AACBL2 setup, but it’s important to know…

view full answer...

Answer 9

If your 2021 Mercedes-Benz Sprinter 3500 is a van then yes, the Roadmaster Rear Anti-Sway Bar #RM43VR is the only compatible option. If your 2021 Mercedes-Benz Sprinter 3500 is a Class C motorhome then you also have the option of the Roadmaster Rear…

view full answer...

Answer 10

Hi Gary, I completely understand why you’re hesitant to just pour this into your fresh tank. Since BluTech’s site says to call if you do not have the filtration system, it makes sense that you would want a clear and safe way to use it. The Blu…

view full answer...

Answer 11

Hello Theresa, Yes, the TorkLift GlowStep Revolution #TLA8002 will work on your 2022 Forest River Aurora 18BHS based on the measurements you provided. Your 24 inch ground clearance is right within the operating range for the 2-step #TLA8002, and the…

view full answer...

How are the Lippert Replacement Kwikee Steps Extended for Install

Product Page this Question was Asked From

Continue Researching