Troubleshooting Frame Weld Nut Broke Off Inside Frame On a 2005 Chrysler Town and Country Receiver

Updated 09/27/2022 | Published 09/26/2022

Question:

Installing this hitch on a 2005 Chrysler Town and Country Touring WITH Stow n Go seats. When removing one of the M12 bolts, the welded nut inside the frame broke loose. I had to cut the bolt off, and make a small access hole nearby so that I could install a bolt down thru the hole. I could only find a 1/2inch Grade 8.8 bolt, rather than the original M12 10.9 grade bolt. Will this bolt be ok, or do I need to source a 10.9 grade bolt? Thanks.

asked by: Jon E

Expert Reply:

You will want to use an equivalent strength bolt and nut to the one that came off of your 2005 Chrysler Town and Country. As the Draw-Tite Max-Frame Trailer Hitch Receiver # 75305 was designed with the factory hardware size and strength rating it is important to ensure that the replacement has the same or more strength than the original hardware so you will not have any issues with the receiver down the road. As the weld nut inside your frame is a factory component you might need to have it inspected by your local Chrysler dealer to ensure the frame there is not weakened and it can still support the receiver.

expert reply by: Bud M