bing tracking image
Q & A Icon

Where Does the Transmitter for the Custer Wireless LED Tow Bar Light Go  

Updated 07/30/2024 | Published 09/15/2022

Question:

Does the transmitter connect in the rv motorhomes harness cord

0

Expert Reply:

The 4-pin round connector that includes the transmitter for the Custer Wireless LED Tow Bar Light # LIW-LDTL will plug into the 4-pin connector on your motorhome and then transmit the signal to the light bar.

If you do not have a 4-pin round connector on your motorhome, you would need to add one. You can do this using the Pollak 4-Pole Round Wiring Socket # PK11404. Once you have the plug, you then need to route 16-gauge wire # 16-4B-1 to those pins into your current wiring.

I have attached a diagram of a 4-way round pin setup along with a help article that talks about a 4-way install.

expert reply by:
0
Scott S
4 pin round diagram
4 pin round diagram
(click to enlarge)
Justin profile picture

Justin

7/29/2024

Is there not an adapter for a 7 way plug?

Jameson C. profile picture
Etrailer Expert

Jameson C.

7/29/2024

@Justin are you looking to go from a 4-way round to a 7-way? Male to male if so?
Justin profile picture

Justin

7/30/2024

@JamesonC I believe that I need 7 way round female to 4 way round. This way I would not have to put another plug in for this light
Jameson C. profile picture
Etrailer Expert

Jameson C.

7/30/2024

@Justin Something like the part # HM47044?

Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>